Delta D29382 instruction manual Read and Understand ALL Warnings Before Starting Unit

READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNIT

When using the high pressure setting, DO NOT allow the high pressure spray to come in contact with unprotected skin,

eyes, or with any pets or animals. Serious injury can occur.

Your washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh, which could result in amputation or other serious injury. Leaks caused by loose fittings or worn or damaged hoses can result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician immediately!

Never pull water supply hose to move pressure washer. This could damage hose and/or pump inlet.

DO NOT use hot water, use cold water only.

Never turn water supply off while pressure washer motor is running or damage to pump will result.

This unit is equipped with an automatic stop mode. When the trigger is released the motor is shut off automatically. When the trigger is pressed again the motor will automatically start. The time between release and engagement must not be less than 4-5 seconds. DO NOT leave the unit in automatic stop mode for more than 15 minutes.

Stand on a stable surface and grip gun/wand firmly with both hands. Expect the gun to kick when triggered.

This product is intended for intermittent use only. Operate pressure washer one hour or less in a 2 hour period.

If you do not understand these precautions please call 1-866-422-4286 to speak to a service representative for further instructions.

BEFORE STARTING

1.Move pressure washer to level ground.

2.Make sure the ON/OFF switch is in the OFF position

To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands. Do not

use if cord is damaged.

3.Plug the unit into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. See the GROUNDING paragraph.

4.Press reset button and indicator light (a) will appear. You will have one of the following GFCI switches shown below.

c

a

b

c

a b

a

c

b

5.Test GFCI switch before each use, to test:

a.Press test button (b), indicator light will disappear.

c.Press reset button (c) to use unit. If indicator light does not reappear DO NOT use unit, see troubleshooting guide.

11- ENG D29382