Campbell Hausfeld PW2570 Operation, Surface Preparation, Start Up, Initial High Pressure Rinse

Page 7

Pressure Washer

Operation

1. Surface Preparation

The following cleaning procedure will help you organize your cleaning task and ensures that you will achieve the best results in the shortest amount of time.. Remember to use the spraying / cleaning techniques mentioned in the following section..

Before starting a pressure washer cleaning job, prepare the surface you intend to clean.. Clear furniture from the area and make sure that all windows and doors are closed tightly.. Also, protect all plants and trees near the cleaning area with a drop cloth.. A covering ensures that your plants won’t be sprayed by the detergents..

2. Start Up

ALWAYS use the following start up procedure to ensure that the unit is started safely and properly..

If water has frozen in the pressure washer, thaw the pressure washer in a

warm room before starting. DO NOT pour hot water on or into the pump; internal parts will be damaged.

1..Check engine oil levels.. Add oil as necessary..

2..Check fuel level.. Add unleaded gasoline (rated 86 octane or higher) as required..

the rope as it returns.. Repeat these steps until the engine starts..

Figure 10 - Start the engine

do NOT refuel a hot engine. Refueling a hot engine could cause a fire. Use

only fresh, clean regular or unleaded gasoline. Close the fuel shutoff valve during refueling.

3..Attach a garden hose to the inlet side of the pump and connect it to the water supply.. Use a hose with an internal diameter (I..D..) of 5/8 inch (1..58 cm) and a length of 50 ft.. (15 m) or less..

some local plumbing codes require backflow prevention when connecting to

a fresh water supply. Install a backflow preventer upstream from the pump if necessary.

a..If inlet water pressure is over 100 psi, install a regulating water valve at the garden hose connection..

b. Do not exceed 100° F (38° C) inlet water temperature..

NOTE: The inlet water supply must have a minimum flow rate of 5 gpm (19 lpm)..

4.. Turn the water supply ON..

never run the unit dry. Be sure the water supply is completely turned on before

operating the unit.

5..Trigger the gun until water sprays smoothly from the tip indicating that all air is purged from the system.. Lock the trigger safety latch..

6.Open the fuel valve by turning the knob counterclockwise until it stops.. Close the choke (if engine is cold) by moving the choke ring fully to the right.. Turn the ignition switch to “ON”..

7.Start the engine.. Unlock the trigger safety latch on the gun (See Figure 9).. Grasp the starter rope and brace one foot on the chassis.. Point the gun in a safe direction.. While squeezing the trigger on the gun, pull the starter rope rapidly and firmly (See Figure 10).. Continue holding

when pulling the starter rope, make sure to keep your hand and arm clear of

the engine and cart components.

never let the starter rope return by itself. Doing so could jam the recoil

system.

8.If the engine does not start after two or three pulls or if the rope is hard to pull, squeeze the gun trigger to release the pressure that has built up in the high pressure hose.. Repeat Steps 7 and 8 until the engine starts..

3.Initial High Pressure Rinse

Spray the cleaning surface with water to clear off any dirt or grime that may have collected on the surface.. Doing so allows the detergent to attack the deep down dirt that has worked its way into the cleaning surface..

Angle to the cleaning surface

When spraying water against a surface, you can generate maximum impact by striking the surface head on.. However, this type of impact can cause dirt particles to embed in the surface and can prevent the desired cleaning action..

The optimum angle for spraying water against a cleaning surface is 45 degrees (See Figure 11)..

Spray water against a surface at a 45 degree angle to achieve the most beneficial impact force and to efficiently remove debris..

7

www.chpower.com

 

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Operating Instructions and Parts List PW2570 Gasoline Powered Pressure WashersPW2570 Getting To Know Your Pressure WasherCall Campbell Hausfeld at Frequently Asked QuestionsCalifornia propostion Safety and Warning InformationPre-Operation AssemblyUnpacking Connect high pressure hose to pump Trigger safety latchStart Up Angle to the cleaning surfaceOperation Surface PreparationDetergent Application Detergents Distance from cleaning surfaceHow to avoid damaging surfaces General Cleaning TipsShutdown Cleaning Power StoragePressure Relief Procedure Final RinseMaintenance Service Record Replacement Parts List --- PumpPM343501SJ For replacement parts or technical assistance, Call1213 2019 1516 Replacement Parts List --- Vertical Shaft Pressure WasherSymptom Possible Causes Corrective Action Pressure Washer Limited Warranty 17 Sp Manual de Instrucciones y Lista de Piezas PW257018 Sp Conozca su lavadora a presión¡No devuelva la lavadora de presión al Comerciante Preguntas formuladas con frecuenciaLlame a Cambpell Hausfeld al 19 Sp 20 Sp Información de Advertencia y seguridadProposición DE California Guarde Estas InstruccionesEnsamblaje Información de Advertencia y seguridad ContinuaciónAntes de Poner en Funcionamiento DesempacadoSeguro del gatillo Antes de Poner en Funcionamiento Continuación22 Sp Ángulo CON Respecto a LA Superficie a Limpiar FuncionamientoDistancia a LA Superficie DE Limpieza Funcionamiento ContinuaciónCómo Evitar Daños a LA Superficie Instrucciones DE Preparación Para EL Invierno Instrucciones Para EL Cambio DEL Aceite DEL Motor MantenimientoInstrucciones Para EL Cambio DE Aceite DE LA Bomba 27 Sp Registro de Servicio y Mantenimiento28 Sp Bombas PM343501SJ29 Sp Hidrolavadora de Eje Vertical30 Sp Problema Posibles causas Acción a tomar31 Sp Notas32 Sp Garantia Limitada

PW2570 specifications

The Campbell Hausfeld PW2570 is a powerful and versatile pressure washer that stands out as an exceptional solution for a range of outdoor cleaning tasks. With its impressive 2700 PSI and a flow rate of 2.3 GPM, this electric pressure washer is designed to tackle even the toughest dirt and stains, making it ideal for cleaning driveways, sidewalks, decks, patios, and vehicles.

One of the main features of the PW2570 is its powerful 190cc OHV engine, which offers reliability and consistent performance. This engine is well-engineered to ensure efficient fuel consumption while delivering maximum power, making it both effective and economical. The unit's durable construction includes a robust steel-frame design that enhances stability and extends the lifespan of the machine.

The PW2570 comes equipped with a variety of pressure settings, allowing users to customize their cleaning experience. The adjustable pressure feature makes it easy to switch between high pressure for tough grime and lower pressure for more delicate surfaces, ensuring that no damage is done during the cleaning process. The pressure washer also includes a range of quick-connect nozzles, giving users the flexibility to tackle different surfaces efficiently.

A standout characteristic of the Campbell Hausfeld PW2570 is its easy-to-use design. The integrated detergent tank simplifies the application of cleaning solutions, enabling users to mix and apply soap with just a flip of a switch. Furthermore, the 25-foot high-pressure hose provides ample reach for larger areas without the need to constantly reposition the unit.

For ease of transportation and maneuverability, the PW2570 features large, rugged wheels that can easily navigate over various terrains. The built-in handle is ergonomically designed, ensuring user comfort during operation. Additionally, the compact nature of the machine facilitates easy storage when not in use.

In summary, the Campbell Hausfeld PW2570 pressure washer combines power, versatility, and ease of use to deliver exceptional cleaning performance. With its robust engine, adjustable pressure settings, and user-friendly features, this pressure washer is well-suited for both homeowners and professionals seeking a reliable cleaning solution for a myriad of outdoor tasks. Whether it’s removing stubborn stains or cleaning large areas, the PW2570 is a valuable tool for maintaining a clean and inviting exterior.
Top Page Image Contents