Briggs & Stratton 020244-0 Assembly, Preparing Pressure Washer for USE, Carton Contents

CleanShot™ 2050 PSI Pressure Washer

ASSEMBLY

IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.

5.Connect high pressure hose to spray gun and pump.

6.Connect water supply to pump.

7.Attach nozzle extension to spray gun.

Remove Pressure Washer From Carton

1.Remove the parts bag, accessories, and inserts included with pressure washer.

2.Slice two corners at the end of carton from top to bottom so the panel can be folded down flat.

3.Remove pressure washer from carton.

Carton Contents

Items in the carton include:

•Main Unit

•Handle

•High Pressure Hose

•Spray Gun

•Adjustable Nozzle Extension

•Safety Goggles

•Oil Bottle

•Parts Bag (which includes the following):

•Owner’s Manual

•Engine Manual

•Owner’s Registration Card

•Handle Fastening Hardware Kit (which includes):

•Carriage Bolts (2)

•“L” Hooks (2)

•Plastic Knobs (4)

PREPARING PRESSURE WASHER FOR USE

If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available.

To prepare your pressure washer for operation, you will need to perform these tasks:

1.Fill out and send in registration card.

2.Attach handle to main unit.

3.Add oil to engine crankcase.

4.Add fuel to fuel tank.

Attach Handle

1.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).

Figure 1 — Attach Handle to Base

Handle

Align Holes

Handle

Supports

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

2.Insert carriage bolts through holes from outside of unit and attach a plastic knob from inside of unit (Figure 2).Tighten by hand.

Figure 2 — Secure Handle

3.Insert one “L” hook through hole just above billboard on left side of handle (viewing from rear of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.

Figure 3 — Attach “L” Hooks to Handle

Hose Hook

Spray Gun Hook

4.Insert other “L” hook through hole just above billboard on right side of handle (viewing from rear of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.

6