
Speed Clean™ 2500 PSI Pressure Washer
TROUBLESHOOTING
Problem | Cause | Correction | |||
  | 1.  | Nozzle in low pressure mode.  | 1.  | Pull nozzle backward for high pressure  | |
  | 
  | 
  | 
  | mode.  | |
  | 2.  | Water inlet is blocked.  | 2.  | Clear inlet.  | |
Pump has following | 3.  | Inadequate water supply.  | 3.  | Provide adequate water flow.  | |
4.  | Inlet hose is kinked or leaking.  | 4.  | Straighten inlet hose, patch leak.  | ||
problems: failure to  | |||||
5.  | Clogged inlet hose strainer.  | 5.  | Check and clean inlet hose strainer.  | ||
produce pressure, erratic  | |||||
6.  | Water supply is over 100°F.  | 6.  | Provide cooler water supply.  | ||
pressure, chattering, loss  | |||||
7.  | High pressure hose is blocked or  | 7.  | Clear blocks in outlet hose.  | ||
of pressure, low water  | |||||
  | leaks.  | 
  | 
  | ||
volume. | 
  | 
  | 
  | ||
8.  | Gun leaks.  | 8.  | Replace gun.  | ||
  | |||||
  | 9.  | Nozzle is obstructed.  | 9.  | Clean nozzle.  | |
  | 10.  | Pump is faulty.  | 10.  | Contact Briggs and Stratton service  | |
  | 
  | 
  | 
  | facility.  | |
  | 1.  | Detergent siphoning tube is not  | 1.  | Insert detergent siphoning tube into  | |
  | 
  | submerged.  | 
  | detergent.  | |
Detergent fails to mix  | 2.  | Chemical filter is clogged or cracked.  | 2.  | Clean or replace filter/detergent  | |
  | 
  | 
  | siphoning tube.  | ||
with spray. | 
  | 
  | 
  | ||
3.  | Dirty   | 3.  | See “Check   | ||
  | |||||
  | 4.  | Nozzle is in high pressure mode.  | 4.  | Push nozzle forward for low pressure  | |
  | 
  | 
  | 
  | mode.  | |
Pressure washer stops  | Out of gasoline.  | Fill fuel tank.  | |||
during operation.  | 
  | 
  | 
  | 
  | |
15