Briggs & Stratton 20258 manual Pressure Washer Rinsing, Cleaning Detergent Siphoning Tube

Page 12

Section 4: Operation

5.Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump; start engine.

6.Apply detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes. DO NOT allow detergent to dry on (prevents streaking).

7.Allow detergent to soak in between 3–5 minutes before washing and rinsing. Reapply as needed to prevent surface from drying.

IMPORTANT:You must flush the injection system after each use by placing the filter into a bucket of clean water, then run the pressure washer in low pressure for 1-2 minutes.

Pressure Washer Rinsing

After you have applied detergent, scour the surface and rinse it clean as follows:

1.Engage trigger lock on spray gun.

2.Remove black detergent spray tip from nozzle extension.

3.Select and install desired high pressure spray tip following the instructions in “How to Use Spray Tips”.

4.Keep spray gun a safe distance from the area you plan to spray.

WARNING

High pressure spray could cause you to fall if you are too close to the cleaning surface.

•Keep spray nozzle between 8 to 24 inches away from cleaning surface.

•Operate this unit on a stable surface.

•Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.

•Firmly grasp spray gun with both hands when using high pressure spray to avoid injury when gun kicks back.

5.Increase (decrease) spray pressure by turning pressure control knob clockwise (counterclockwise) (See “Know Your Pressure Washer”). Use lower pressure to wash items such as a car or boat. Use higher pressure to strip paint and degrease driveways.

6.Apply high pressure spray to small area and then check surface for damage. If no damage is found, you can assume it is okay to continue cleaning.

7.Start at top of area to be rinsed, working down with same overlapping strokes as used for cleaning.

Cleaning Detergent Siphoning Tube

If you used the detergent siphoning tube, you must flush it with clean water before stopping the engine.

1.Place detergent siphon tube/filter in a bucket full of clean water.

2.Engage trigger lock on spray gun.

3.Attach black cleaning detergent nozzle.

4.Flush for 1-2 minutes.

5.Shut off engine.

6.ALWAYS point gun in a safe direction and squeeze spray gun trigger to release retained high water pressure.

IMPORTANT: Spray gun traps high water pressure, even when engine is stopped and water is disconnected.

Automatic Cool Down System

(Thermal Relief)

If you run the engine on your pressure washer for

3-5 minutes without pressing the trigger on the spray gun, circulating water in the pump can reach temperatures above 125°F.The system engages to cool the pump by

discharging the warm water onto the ground.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Advertencia Antes de utilizar el producto, lea este manualTable of Contents Safety RulesEquipment Description When Adding Fuel Operate pressure washer only outdoorsUnintentional sparking can result in fire or electric shock High pressure spray may damage fragile items including glass Section Features and Controls Know Your Pressure WasherChoke Lever Recoil StarterAssembly Section AssemblyPreparing Pressure Washer for USE Assembly Checklist Before Starting EngineAdd Engine Oil and Fuel Connect Hose and Water Supply to PumpHOW to USE Pressure Washer How to Start EngineOperation Section Pressure Washer LocationHow to Stop Pressure Washer OperationHow to Use Spray Tips Cleaning and Applying DetergentCleaning Detergent Siphoning Tube Pressure Washer RinsingAutomatic Cool Down System Thermal ReliefMaintenance Section SpecificationsGeneral Maintenance Recommendations Pressure Washer MaintenanceMaintenance Engine MaintenanceNozzle Maintenance Ring MaintenancePump Maintenance Oil Change ProcedureMaintenance Item Daily Hours Check Oil LevelStorage Preparing the Unit for StorageStoring the Engine Protecting the PumpTroubleshooting TroubleshootingCAT Pumps Warranty This Warranty is Subject to the Following ConditionsLimited Warranty Reglas de Seguridad Conserve Estas InstruccionesSección 1 Reglas de Seguridad Cuando Añada CombustibleCuando Pruebe LA Bujía DEL Motor Precaución Características y Controles Conozca SU Maquina Lavadora DE PresionMontaje MontajePreparando EL Lavador a Presión Para SU USO Sección 3 Montaje Conecte la Manguera y el Suministro de Agua a la BombaLista de Revision Previa al Arranque del Motor Operación Cómo Usar SU Lavadora a PresiónUbicación del Lavadora a Presión Cómo Darle Arranque a su Lavadora a PresiónSección 4 Operación Cómo Parar su Lavador a PresiónCómo Usar las Puntas de Rociado Limpieza y Aplicación del DetergentePara aplicar el detergente, siga los siguientes pasos La Presión BajaEnjuage de la Máquina Lavadora a Presión Limpiando el TuboSistema de Enfriamiento Automático Alivio Térmico Mantenimiento EspecificacionesRecomendaciones Generales Mantenimiento DE LA Lavadora a PresionSección 5 Mantenimiento Mantenimiento DEL MotorMantenimiento de la Puntas de Rocío Mantenimiento de los Anillos OMantenimiento DEL Bomba Compruebe el Nivel de AceiteProcedimiento de Cambio de Aceite Coloque la limpiadora a presión en una superficie planaAlmacenamiento Preparando LA Unidad Para SU AlmacenamientoAlmacenando EL Motor Proteger la BombaDiagnosticos de Averías Diagnosticos DE AveríasProblema SoluciónUso del consumidor Uso comercial

20258 specifications

The Briggs & Stratton 20258 is a versatile and reliable portable generator designed to meet a wide range of power needs. This compact generator is ideal for homeowners, outdoor enthusiasts, and those who need backup power during outages. With its combination of innovative technology and robust features, the 20258 stands out as a dependable choice in the generator market.

One of the key features of the Briggs & Stratton 20258 is its powerful engine. The generator is equipped with a reliable 7500-watt starting capacity and a running capacity of 6000 watts, making it capable of powering essential appliances such as refrigerators, sump pumps, and lights during emergencies. This high output ensures that users can maintain critical functions in their homes without significant interruption.

The 20258 has a user-friendly control panel that includes multiple outlets, allowing for easy connection of various devices. It features four 120V 20A outlets, one 120V 30A twist-lock outlet, and one 12V DC outlet for charging batteries, providing versatility for different power needs. The inclusion of a circuit breaker enhances safety by preventing overloads and ensuring the generator operates efficiently.

In terms of technology, the Briggs & Stratton 20258 is designed with a durable steel frame for enhanced protection and longevity. Its portable design incorporates rugged wheels and a foldable handle, making transport convenient, whether for home use or outdoor activities. This generator also features an easy-start system, allowing users to fire up the engine with minimal effort, even in cold weather.

Another notable characteristic of the 20258 is its Quiet Power Technology, which significantly reduces noise levels during operation. This makes it a suitable choice for residential use where noise restrictions may apply. The generator runs smoothly and quietly, enhancing user comfort and reducing the impact on the surrounding environment.

Maintenance is a breeze with the 20258, thanks to its easy-access oil fill and extended run times. With a fuel tank capacity of 7.5 gallons, this generator can operate for up to 10 hours at half-load, ensuring ample power supply without frequent refueling.

Overall, the Briggs & Stratton 20258 combines power, portability, and advanced technology, making it an excellent option for anyone in need of reliable, temporary power. Whether for emergency backup or recreational use, this generator delivers on both performance and convenience.
Top Page Image Contents