Section 4: Operation
Pressure Washer Rinsing
For Rinsing:
1.Engage trigger lock on spray gun.
2.Remove black detergent spray tip from nozzle extension.
3.Select and install desired high pressure spray tip following instructions “How to Use Quick Connect Spray Tips”.
4.Keep spray gun a safe distance from the area you plan to spray.
WARNING
High pressure spray could cause you to fall if you are too close to the cleaning surface.
•Keep spray nozzle between 8 to 24 inches away from cleaning surface.
•Operate this unit on a stable surface.
•Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.
•Firmly grasp spray gun with both hands when using high pressure spray to avoid injury when gun kicks back.
5.Apply a high pressure spray to a small area and then check the surface for damage. If no damage is found, you can assume it is okay to continue rinsing.
6.Start at top of area to be rinsed, working down with same overlapping strokes as you used for cleaning.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it with clean water before stopping the engine.
1.Place detergent siphoning tube/filter in a bucket full of clean water.
2.Engage trigger lock on spray gun.
3.Attach black detergent spray tip.
4.Flush for
5.Shut off engine.
6.ALWAYS point gun in a safe direction and squeeze spray gun trigger to release retained high water pressure.
IMPORTANT: Spray gun traps high water pressure, even when engine is stopped and water is disconnected.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
discharging the warm water onto the ground.
14