Briggs & Stratton 020211-0 Add Engine Oil and Fuel, Connect Hose and Water Supply to Pump

Page 7

SpeedClean™ 2000 PSI Pressure Washer

Add Engine Oil and Fuel

• Place pressure washer on a level surface.

CAUTION

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

•Refer to engine owner’s manual and follow oil and fuel recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to engine owner’s manual for recommendations.

Connect Hose and Water Supply to Pump

IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.

1.Uncoil high pressure hose and attach one end of hose to base of spray gun (Figure 4).Tighten by hand.

Figure 4 — Connect High Pressure Hose to Spray Gun

Connect high pressure

hose here

NOTE: Remove and discard all pump shipping caps before attaching hoses.

2.Attach other end of high pressure hose to high pressure outlet on pump (Figure 5).Tighten by hand.

Figure 5 — Connect High Pressure Hose to Pump

3.Before connecting garden hose to water inlet, inspect inlet screen (Figure 6). Clean screen if it contains debris or have it replaced if damaged. DO NOT RUN PRESSURE WASHER IF INLET SCREEN IS DAMAGED.

Figure 6 — Connect the Garden Hose to Water Inlet

Inspect inlet

screen, DO NOT

use if damaged;

clean if dirty.

4.Run water through your garden hose for 30 seconds to clean out any debris.

IMPORTANT: DO NOT siphon standing water for the water supply. Use ONLY cold water (less than 100°F).

5.Connect the garden hose (not to exceed 50 feet in length) to the water inlet.Tighten by hand (Figure 6).

CAUTION

There MUST be at least ten feet of unrestricted garden hose between the pressure washer inlet and any flow shut off device, such as a ‘Y’ shut-off connector or other convenience-type water shut-off valve.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

6.Turn ON the water and squeeze the trigger on the gun to purge the pump system of air and impurities.

WARNING

High pressure spray can cause paint chips or other particles to become airborne.

•Always wear eye protection when using this equipment or in vicinity of where equipment is in use.

•Before starting the pressure washer, be sure you are wearing adequate eye protection.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents 2000PSI Safety Rules Table of ContentsEquipment Description When Transporting or Repairing Equipment High pressure spray may damage fragile items including glass Data Tag not shown, near rear of base plate Know Your Pressure WasherRemove Pressure Washer From Carton AssemblyCarton Contents Preparing Pressure Washer for USEConnect Hose and Water Supply to Pump Add Engine Oil and FuelHow to Stop Your Pressure Washer Checklist Before Starting EngineHOW to USE Your Pressure Washer How to Start Your Pressure WasherAdjusting Nozzle for Pressure How to Use the Adjustable NozzleThermal Relief Applying Detergent with the Adjustable NozzlePressure Washer Rinsing Automatic Cool Down SystemGeneral Maintenance Recommendations SpecificationsPressure Washer Maintenance Orifice Nozzle MaintenanceCheck In-Line Filter To remove contaminants from the pump, follow these stepsPump Maintenance Engine MaintenanceRing Maintenance Cleaning Chemical Injection HoseStoring the Engine Preparing the Unit for StorageProtecting the Pump Problem Cause Correction TroubleshootingDescription Exploded View and Parts List Main UnitItems Not Illustrated Description Exploded View and Parts List Pump SpeedClean 2000 PSI Pressure Washer Limited Warranty Advertencia Tabla DE ContenidosDescripción DEL Equipo Reglas DE SeguridadCuando Añada Combustible PeligroPrecaución Conozca SU Maquina Lavadora DE Presion Contenido de la Caja MontajePreparando EL Lavador a Alta Presión Para SU USO Remueva el Lavador a Presión del EmpaqueConecte la Manguera y el Suministro de Agua a la Bomba Agregar Aceite al Motor y GasolinaCómo Darle Arranque a su Máquina Lavadora a Presión Lista DE Revision Previa AL Arranque DEL MotorCómo Usar SU Máquina Lavadora a PresiónFigura 24 Ajustar la Presión de Aspersión Cómo Usar la Boquilla AjustablePara aplicar el detergente, siga los siguientes pasos Aplicación del Detergente Usando la Boquilla AjustableEnjuage de la Máquina Lavadora a Presión Sistema de Enfriamiento Automático Alivio TérmicoRecomendaciones Generales EspecificacionesMantenimiento DE LA Maquina Lavadora a Presion Mantenimiento de la Boquilla Revise el Filtro en LíneaBoquilla Mantenimiento de la Bomba Mantenimiento DEL MotorMantenimiento de los Anillos O Limpiando el TuboAlmacenando EL Motor Preparando LA Unidad Para SU AlmacenamientoProteger la Bomba Notas Notas Reparacion DE Averias Garantía Limitada

020211-0 specifications

Briggs & Stratton is a renowned name in the world of small engine manufacturing, and one of their standout products is the Briggs & Stratton 020211-0 generator. This generator is designed to provide reliable backup power for homeowners, ensuring that essential appliances and devices remain operational during power outages.

The Briggs & Stratton 020211-0 features a robust engine that delivers consistent performance. It is equipped with a powerful 306cc OHV engine that efficiently converts fuel into energy, ensuring a steady output. This model is particularly known for its durability and long runtime capabilities, making it ideal for both emergency situations and recreational use.

One of the hallmark features of the 020211-0 is its portable design. It is lightweight yet sturdy, allowing users to easily transport the generator wherever needed. The generator also comes with built-in wheels and a handle, making mobility effortless. This portability makes it an excellent choice for camping trips, tailgating events, or any outdoor activity where access to power is required.

In terms of power output, the 020211-0 has a running wattage of 5000 and a peak wattage of 6250, providing ample energy to run household appliances such as refrigerators, air conditioning units, and power tools. This capability is especially important during severe weather, when electrical outages are most common.

Safety is a major consideration in the design of the Briggs & Stratton 020211-0. The generator is equipped with a Low Oil Shutdown feature, which helps prevent engine damage by automatically shutting off the engine when oil levels drop too low. Additionally, the generator has a circuit breaker for added protection against overloads.

Another significant characteristic of the 020211-0 is its ease of operation. The electric start feature allows users to start the generator quickly and conveniently, eliminating the hassles of recoil starters. This user-friendly approach ensures that even those new to generators can operate it with confidence.

In summary, the Briggs & Stratton 020211-0 generator combines powerful performance, portability, safety features, and ease of use. Whether you need backup power for emergencies or additional power for recreational activities, this generator proves to be a reliable choice that meets diverse power needs. Its blend of technology and durability makes it a top contender in the generator market, a testament to Briggs & Stratton's commitment to quality and innovation.
Top Page Image Contents