Briggs & Stratton 020211-0 Checklist Before Starting Engine, HOW to USE Your Pressure Washer

Page 8

SpeedClean™ 2000 PSI Pressure Washer

CHECKLIST BEFORE STARTING ENGINE

5.Attach adjustable nozzle extension to spray gun (Figure 7).Tighten by hand.

Figure 7 — Connect Nozzle Extension to Spray Gun

Review the unit’s assembly to ensure you have performed all of the following.

1.Make sure handle is in place and secure.

2.Check that oil has been added to proper level in the engine crankcase.

3.Add proper gasoline to fuel tank.

4.Check for properly tightened hose connections.

5.Check to make sure there are no kinks, cuts, or damage to high pressure hose.

6.Provide a proper water supply at an adequate flow.

7.Be sure to read “Safety Rules” and “How To Use Your Pressure Washer” before using pressure washer.

HOW TO USE YOUR PRESSURE WASHER

If you have any problems operating your pressure washer, please call the pressure washer helpline at 1-800-743-4115.

How to Start Your Pressure Washer

To start your pressure washer for the first time, follow these instructions step-by-step.This starting information also applies if you have let the pressure washer sit idle for at least a day.

1.Place pressure washer near an outside water source capable of supplying water at a flow rate greater than 3.0 gallons per minute and no less than 20 PSI at pressure washer end of garden hose.

2.Check that high pressure hose is tightly connected to spray gun and pump. See “Preparing Pressure Washer for Use” for illustrations.

3.Make sure unit is in a level position.

4.Connect garden hose to water inlet on pressure washer pump. Turn ON water.

CAUTION

DO NOT run the pump without the water supply connected and turned on.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

6.Position nozzle in low pressure mode (see “How to Use the Adjustable Nozzle”) and squeeze trigger on spray gun to relieve air pressure caused by turning ON water.Water will flow out of spray gun in a thin stream. Continue to hold trigger until there is a steady stream of water and no air remains in system.This will make it easier to pull start engine. Release trigger.

7.Engage safety latch to spray gun trigger (Figure 8).

Figure 8 — Spray Gun with Safety Latch Engaged

Safety Latch

8.Start engine according to instructions given in engine owner’s manual.

CAUTION

Avoid injury from kickback.

•Squeeze trigger on spray gun each time recoil starter is pulled and engine fails to start.

NOTE: Always keep the throttle lever in the “Fast” position when operating the pressure washer.

How to Stop Your Pressure Washer

1.Let engine idle for two minutes.

2.Turn engine off according to instructions given in engine owner’s manual.

3.Squeeze trigger on the spray gun to relieve pressure in the hose.

NOTE: A small amount of water will squirt out when you release the pressure.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents 2000PSI Equipment Description Table of ContentsSafety Rules When Transporting or Repairing Equipment High pressure spray may damage fragile items including glass Know Your Pressure Washer Data Tag not shown, near rear of base plateAssembly Carton ContentsPreparing Pressure Washer for USE Remove Pressure Washer From CartonAdd Engine Oil and Fuel Connect Hose and Water Supply to PumpChecklist Before Starting Engine HOW to USE Your Pressure WasherHow to Start Your Pressure Washer How to Stop Your Pressure WasherHow to Use the Adjustable Nozzle Adjusting Nozzle for PressureApplying Detergent with the Adjustable Nozzle Pressure Washer RinsingAutomatic Cool Down System Thermal ReliefPressure Washer Maintenance SpecificationsGeneral Maintenance Recommendations Nozzle Maintenance Check In-Line FilterTo remove contaminants from the pump, follow these steps OrificeEngine Maintenance Ring MaintenanceCleaning Chemical Injection Hose Pump MaintenanceProtecting the Pump Preparing the Unit for StorageStoring the Engine Troubleshooting Problem Cause CorrectionItems Not Illustrated Description Exploded View and Parts List Main UnitDescription Exploded View and Parts List Pump SpeedClean 2000 PSI Pressure Washer Limited Warranty Tabla DE Contenidos Descripción DEL EquipoReglas DE Seguridad AdvertenciaPeligro Cuando Añada CombustiblePrecaución Conozca SU Maquina Lavadora DE Presion Montaje Preparando EL Lavador a Alta Presión Para SU USORemueva el Lavador a Presión del Empaque Contenido de la CajaAgregar Aceite al Motor y Gasolina Conecte la Manguera y el Suministro de Agua a la BombaLista DE Revision Previa AL Arranque DEL Motor Cómo Usar SU MáquinaLavadora a Presión Cómo Darle Arranque a su Máquina Lavadora a PresiónCómo Usar la Boquilla Ajustable Figura 24 Ajustar la Presión de AspersiónAplicación del Detergente Usando la Boquilla Ajustable Enjuage de la Máquina Lavadora a PresiónSistema de Enfriamiento Automático Alivio Térmico Para aplicar el detergente, siga los siguientes pasosMantenimiento DE LA Maquina Lavadora a Presion EspecificacionesRecomendaciones Generales Boquilla Revise el Filtro en LíneaMantenimiento de la Boquilla Mantenimiento DEL Motor Mantenimiento de los Anillos OLimpiando el Tubo Mantenimiento de la BombaProteger la Bomba Preparando LA Unidad Para SU AlmacenamientoAlmacenando EL Motor Notas Notas Reparacion DE Averias Garantía Limitada

020211-0 specifications

Briggs & Stratton is a renowned name in the world of small engine manufacturing, and one of their standout products is the Briggs & Stratton 020211-0 generator. This generator is designed to provide reliable backup power for homeowners, ensuring that essential appliances and devices remain operational during power outages.

The Briggs & Stratton 020211-0 features a robust engine that delivers consistent performance. It is equipped with a powerful 306cc OHV engine that efficiently converts fuel into energy, ensuring a steady output. This model is particularly known for its durability and long runtime capabilities, making it ideal for both emergency situations and recreational use.

One of the hallmark features of the 020211-0 is its portable design. It is lightweight yet sturdy, allowing users to easily transport the generator wherever needed. The generator also comes with built-in wheels and a handle, making mobility effortless. This portability makes it an excellent choice for camping trips, tailgating events, or any outdoor activity where access to power is required.

In terms of power output, the 020211-0 has a running wattage of 5000 and a peak wattage of 6250, providing ample energy to run household appliances such as refrigerators, air conditioning units, and power tools. This capability is especially important during severe weather, when electrical outages are most common.

Safety is a major consideration in the design of the Briggs & Stratton 020211-0. The generator is equipped with a Low Oil Shutdown feature, which helps prevent engine damage by automatically shutting off the engine when oil levels drop too low. Additionally, the generator has a circuit breaker for added protection against overloads.

Another significant characteristic of the 020211-0 is its ease of operation. The electric start feature allows users to start the generator quickly and conveniently, eliminating the hassles of recoil starters. This user-friendly approach ensures that even those new to generators can operate it with confidence.

In summary, the Briggs & Stratton 020211-0 generator combines powerful performance, portability, safety features, and ease of use. Whether you need backup power for emergencies or additional power for recreational activities, this generator proves to be a reliable choice that meets diverse power needs. Its blend of technology and durability makes it a top contender in the generator market, a testament to Briggs & Stratton's commitment to quality and innovation.
Top Page Image Contents