Taylor Pool Heat Pump owner manual Solving Problems, Error Possible Causes Possible Solutions

SOLVING PROBLEMS

Error		Possible Causes		Possible Solutions
Unit does not run.	1.	Power is not supplied to the	1.	Make sure that the heat pump
	heat pump.		electrical supply line breaker is
	2.	No demand for heat.	ON.
	3.	Anti cycle delay (5 minutes).	2.	Make sure that the
			temperature control is set at a
			proper level. Adjust as required.
			3. Whenever the compressor is
			stopped, the digital control
			imposes a minimal time delay of
			5 minutes before restarting it to
			allow gases to calibrate.
The actual water	Water is not circulating in the		Check connections.
temperature increases	right direction.
when the compressor
starts.
The heat pump runs	1.	Water is not circulating in	1.	Check connections.
but does not generate	the right direction.
enough heat.	2.	The heat loss of the pool	2.	See “Heat Pump Sizing”
	exceeds the heating capacity		section on page 4.
	of the heat pump.		3.	Use a more powerful model or
	3.	The pool size exceeds the	use more than one heat pump.
	specified capacity of the model
	selected.
The heater seems to	1.	Normal - water caused by	1.	No action required.
have a water leak.	condensation.		(Install a derivation drain if
	2.	Water leak.	necessary.)
			2.	To verify if it is a leak, you
			need to stop the pool heat pump
			until all the condensation has
			disappeared. Verify if there is
			water remaining around the
			machine after 24 to 48 hours.
			(See p. 18 Q2)
The defrost sensor	Normal.		No action required.
temperature decreases
when the compressor
starts.
The digital control	The digital display is exposed		Make shade on the display to
displays “888”.	to the sunlight.		distinguish lights that are ON
			from those that are OFF.
Only the fan is running.	1.	Defrost mode.	1.	No action required.
	2.	Anti cycle delay (5 minutes).	2.	No action required.
	3.	Defective compressor.	3.	Call an authorized service
			technician.

24