Zenoah SRTZ2500 manual SE4 Attaching the Trimming Mechanism SE4, Balance Unit,  14 

Page 14

6. Set up

SE4

■ATTACHING THE TRIMMING MECHANISM (SE4)

1. Remove the cap on the end of the main pipe.

2. Remove the screw screwed into the end of the trimming mechanism.

3. Insert the end of the trimming mechanism into the main pipe.

4. Line up the hole on the end of the trimming mechanism into which the screw is to be inserted with the hole on the main pipe, and screw the screw firmly in.

5. Using a 10-mm wrench, screw in the hexagonal bolt provided to fix the trimming mechanism into place.

(1)Main pipe

(2)Trimming mechanism

(3)Screw hole

(4)Screw

(5)Fastening bolt

■BALANCE UNIT

1.Put on strap and attach unit to strap.

2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents SRTZ2500 Information Safety First Contents 4  SpecificationsParts location Avertissement  5 Symbols on the machine  6 Working Circumstance For safe operationWorking Condition  7 Working Plan  8  9  Before Starting the EngineStarting the Engine Using the Product  10  11  MaintenanceIf Someone Comes  12  Handling FuelTransportation Set up  13  14  SE4 Attaching the Trimming Mechanism SE4Balance Unit Recommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel  15  16  Fueling the UnitFor Your Engine LIFE, Avoid OP4 Starting Engine OperationOP1  17  18   19  Adjusting the Angle of the Cutting Blades OP8OP8 MA1 Blades MA1 MaintenanceMaintenance Chart  20 AIR Filter MA2 MA3 MA4 Quick TIPGear Case Fuel Filter 22   23  Procedures to be Performed After Every 100 Hours of USEMA8 Intake AIR Cooling Vent Check Probable Causes Action Troubleshooting guideStorage  24 Parts list  25 Drive Unit SRTZ2500 S/N 000000 and up  26  27  Engine Unit SRTZ2500 S/N 50100000 and up  28  29  DiaphragmLimited Warranty RedMax Garantie limitée Komatsu Zenoah America INC
Top Page Image Contents