Zenoah SRTZ2500 manual For safe operation, Working Condition, Working Circumstance,  7 

Page 7

5. For safe operation

1.Read this manual carefully until you completely understand and follow all safety and operating instructions.

2.Keep this manual handy so that you may refer to it later whenever any questions arise. Also note, if you have any questions which cannot be answered herein, contact the dealer from whom you purchased the product.

3.Always be sure to include this manual when selling, lending, or otherwise transferring the ownership of this product.

4.Never allow children or anyone unable to fully understand the directions given in the manual to use the machine.

WORKING CONDITION

1.When using the product, you should wear proper clothing and protective equipment.

(1)Helmet

(2)Ear protectors

(3)Protection goggles or face protector

(4)Thick work gloves

(5)Non-slip-sole work boots

2.And you should carry with you.

(1)Attached tools and files

(2)Properly reserved fuel

(3)Spare blade

(4)Things to notify your working area (rope, warning signs)

(5)Whistle (for collaboration or emergency)

(6)Hatchet or saw (for removal of obstacles)

3.Do not wear loose clothing, jewelry, short trousers, sandals, or go barefoot. Do not wear anything which might be caught by a moving part of the unit. Secure hair so it is above shoulder length.

WORKING CIRCUMSTANCE

1. Never start the engine inside a closed room or building. Exhaust gases contain dangerous carbon monoxide.

2.Never use the product,

a.when the ground is slippery or when you can’t maintain a steady posture.

7

Image 7
Contents SRTZ2500 Information Contents Safety FirstParts location Specifications 4   5  Avertissement 6  Symbols on the machine 7  For safe operationWorking Condition Working Circumstance 8  Working PlanStarting the Engine Before Starting the Engine 9   10  Using the ProductIf Someone Comes Maintenance 11  Transportation Handling Fuel 12   13  Set upBalance Unit SE4 Attaching the Trimming Mechanism SE4 14   15  HOW to MIX FuelFuel Recommended Mixing Ratio Gasoline 50OILFor Your Engine LIFE, Avoid Fueling the Unit 16   17  OperationOP1 OP4 Starting Engine 18  OP8 Adjusting the Angle of the Cutting Blades OP8 19   20  MaintenanceMaintenance Chart MA1 Blades MA1Fuel Filter MA2 MA3 MA4 Quick TIPGear Case AIR Filter 22  MA8 Intake AIR Cooling Vent Procedures to be Performed After Every 100 Hours of USE 23   24  Troubleshooting guideStorage Check Probable Causes Action 25  Parts list 26  Drive Unit SRTZ2500 S/N 000000 and up 27   28  Engine Unit SRTZ2500 S/N 50100000 and upDiaphragm  29 Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC