BKZ4500DL / BKZ5000DL
9. Maintenance
REFILLING TRIMMING LINE
1.For replacement line, use a diameter of 2.4mm(.095in). The spool is capable for a line upto 6m(20ft) on the 10cm(4”) head. Avoid using a larger line as it may cut down the trimming performance.
WARNING
• For safety reasons, do not use metalreinforced line.
2.Pinch the slotted area on the both sides of the spool housing to unhook the bottom cap.
3.Take out the spool and pull off the old line. Put one end of new line through the spool holes and pull it until the length is equal between each part of the line.
4.Wind up the line in the correct direction as indicated on the spool.
5.Hook each end of the line in the slot on the edge of the spool, and then put the ends through the eyelets on the housing. Make sure that the spring and the washers are in place.
6.While holding the spool against the housing, pull the line ends to release them from the slot.
7.Line up the slot on the bottom cap with the hook on the housing, press the cap against the housing until it clicks.
AIR FILTER
•The air filter, if clogged, will reduce the engine per- formance. Check and clean the paper element by air blow as required. If the element becomes dirty, re- place with a new one.
(1)
(1) Paper element
FUEL FILTER
•When the engine runs short of fuel supply, check the fuel cap and the fuel filter for blockage.
(1)
(1) Fuel filter
SPARK PLUG
•Starting failure and misfiring are often caused by a fouled spark plug. Clean the spark plug and check that the plug gap is in the correct range. For a re- placement plug, use the correct type specified by
ZENOAH.
WARNING
•Make sure that the engine has stopped and is cool before per- forming any service to the machine. Contact with moving cut- ting head or hot muffler may result in a personal injury.
0.6~0.7 mm
•REPLACEMENT PLUG IS A NGK CMR7H.
IMPORTANT
•Note that using any spark plug other than those des- ignated may result in the engine failing to operate prop- erly or in the engine becoming overheated and dam- aged.
•To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench.
9.8~ 11.8 N.m.
TIGHTENING TORQUE: (1 ~ 1.2 kgm)
MUFFLER
WARNING
•Inspect periodically, the muffler for loose fasten- ers, any damage or corrosion. If any sign of ex- haust leakage is found, stop using the machine and have it repaired immediately.
•Note that failing to do so may result in the engine catching on fire.