BKZ4505DL / BKZ5010DL
8. Operation
STARTING ENGINE
WARNING
•The cutting head will start rotating upon the en- gine starts.
1.Feed fuel into the fuel tank and tighten the cap se- curely.
2.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects, as it will start rotating upon starting of the engine.
3.Push the primer several times until overflown fuel flows out in the clear tube.
WARNING
•The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to rotate as soon as the engine is started by putting the throttle trigger into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting attachment nor the throttle trigger come into contact with any obstacle when the engine starts.
(1)
4. Move the choke lever to the closed position.
(1)
(2)
(3) | (1) choke lever | |
(2) close | ||
| ||
| (3) open |
5.Set the stop switch to the “RUN” position. Place the unit on a flat, firm place.
Keep the cutting head clear of everything around it.
(1)
(1) stop switch
6.While holding the unit firmly, pull out the starter rope quickly until engine fires.
IMPORTANT
•Avoid pulling the rope to its end or returning it by re- leasing the knob. Such actions can cause starter fail- ures.
7.Move the choke lever downward to open the choke. And restart engine.
8.Allow the engine to warm up for a several minutes before starting operation.
NOTE
1.When restarting the engine immediately after stop- ping it, leave the choke open.
2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.
STOPPING ENGINE
1.Release the throttle trigger and run the engine for half a minute.
2.Shift the stop switch to the STOP position.
(1)
(1) stop switch
IMPORTANT
•Except for an emergency, avoid stopping the engine while pulling the throttle trigger.