BK2650DL
8. Operation
ADJUSTING THE LINE LENGTH
•Your brush cutter is equipped with a semi- auto type nylon line head that allows the operator to advance the line without stopping the engine. When the line becomes short, lightly tap the head on the ground while running the engine at full throttle.
9. Maintenance
•Each time the head is bumped, the line advances about 25 mm. For better effect, tap the head on bear ground or hard soil. Avoid bumping in thick, tall grass as the engine may stall by overload.
G |
B |
|
|
|
| Every | Every | Every |
|
| System/components | Procedure | Before | 25 | 50 | 100 | Note |
| use | hours | hours | hours | |||
|
|
|
| ||||
|
|
|
| after | after | after |
|
| fuel leaks, fuel spillage | wipe out | ✔ |
|
|
|
|
| fuel tank, air filter, fuel filter | inspect/clean | ✔ | ✔ |
|
| replace, if necessary |
| idle adjusting screw | see adjusting | ✔ |
|
|
| replace carburetor |
ENGINE | idling speed |
|
|
| if necessary | ||
|
|
|
|
| |||
spark plug | clean and readjust |
|
| ✔ |
| GAP: .025 in | |
plug gap |
|
|
| replace, if necessary | |||
|
|
|
|
| |||
|
|
|
|
|
| ||
| cylinder fins, intake air cooling vent | clean |
| ✔ |
|
|
|
| muffler, spark arrester, cylinder exhaust port | clean |
|
| ✔ |
|
|
| throttle lever, ignition switch | check operation | ✔ |
|
|
|
|
| cutting parts | replace if | ✔ |
|
|
|
|
| something’s wrong |
|
|
|
| ||
SHAFT |
|
|
|
|
|
| |
gear case | grease |
| ✔ |
|
|
| |
screws/nuts/bolts | tighten/replace | ✔ |
|
| ✔ | not adjusting screws | |
| debris guard | make sure to attach | ✔ |
|
|
|
|
| flexible shaft | grease, seal |
| ✔ |
|
|
|
REFILLING TRIMMING LINE
1.For replacement line, use a diameter of 2.4mm(.095in). The spool is capable for a line upto 6m(20ft) on the 10cm(4”) head. Avoid using a larger line as it may cut down the trimming performance.
WARNING
•For safety reasons, do not use metalreinforced line.
2.Pinch the slotted area on the both sides of the spool housing to unhook the bottom cap.
3.Take out the spool and pull off the old line. Put one end of new line through the spool holes and pull it until the length is equal between each part of the line.
4.Wind up the line in the correct direction as indicated on the spool.
5.Hook each end of the line in the slot on the edge of the spool, and then put the ends through the eyelets on the housing. Make sure that the spring and the washers are in place.
6.While holding the spool against the housing, pull the line ends to release them from the slot.
7.Line up the slot on the bottom cap with the hook on the housing, press the cap against the housing until it clicks.