Zenoah BC2604DW, BC2604DL owner manual Operation, Starting Engine, Stopping Engine

Page 10

BC2604DL / BC2604DW

8. Operation

STARTING ENGINE

WARNING

The cutting head will start rotating upon the engine starts.

1.Feed fuel into the fuel tank and tighten the cap se- curely.

2.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects, as it will start rotating upon starting of the engine.

3.Push the primer pump several times until overflown fuel flows out in the clear tube.

(1)choke lever

(2)close

(3)open

(4)primer pump

4.Move the choke lever to the closed position.

5.Set the ignition switch to the “I” position. Set the throttle

lever to the start position (1 2 3). Place the unit on a flat, firm place.

Keep the cutting head clear of everything around it.

START

O : Stop

I : Start

3. Ignition switch

BC2604DLBC2604DW

WARNING

The product is equipped with a centrifugal clutch mecha- nism, so the cutting attachment begins to rotate as soon as the engine is started by putting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the en- gine starts.

IMPORTANT

Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

7.Move the choke lever downward to open the choke. And restart engine.

8.Allow the engine to warm up for a several minutes before starting operation.

NOTE

1.When restarting the engine immediately after stopping it, leave the choke open.

2.Overchoking can make the engine hard to start due to ex- cess fuel. When the engine failed to start after several at- tempts, open the choke and repeat pulling the rope, or re- move the spark plug and dry it.

STOPPING ENGINE

6.While holding the unit firmly, pull out the starter rope quickly until engine fires.

GB-10

START

O : Stop

I : Start

3. Ignition switch

BC2604DLBC2604DW

1.Release the throttle lever and run the engine for half a minute.

2.Shift the ignition switch to the STOP position.

IMPORTANT

Except for an emergency, avoid stopping the engine while pulling the throttle lever.

Image 10
Contents BC2604DL BC2604DW Wear head, eye and ear protection E13*97/68SH2G3*2002/88*0104*03Contents Parts locationBC2604DL / BC2604DW SpecificationSymbols on the machine Never modify your machineWorking Circumstance For safe operationWorking Condition Working PlanBefore Starting Engine Using the ProductStarting the Engine Handling Fuel MaintenanceIf Someone Comes TransportationSet up Fuel Cutting head will start rotating upon the engine starts OperationStarting Engine Stopping EngineCutter Application Chart Adjusting Throttle CableAdjusting Idling Speed Metal Blade UsageWhat causes kick out Cutting MethodControlling Blade Bounce How you can maintain the best controlCutting Work Line Head Usage Adjusting the Line LengthTrimming Grass and Weeds AIR Filter MaintenanceReplacement Plug is a Champion RZ7C Fuel FilterMuffler Procedures to be Performed After Every 100 Hours of USEStorage Gear CaseLimited warranty Troubleshooting guideCheck Probable Causes Action