BCZ3000DL / BCZ3000DW
5. For safe operation
could result in serious burns or elec- trical shock.
•IF SOMEONE COMES
1.Guard against hazardous situa- tions at all times. Warn adults to keep pets and children away from the area. Be careful if you are ap- proached. Injury may result from flying debris.
2.If someone calls out or otherwise interrupts you while working, al- ways be sure to turn off the en- gine before turning around.
MAINTENANCE
1. In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals.
2.Always be sure to turn off the en- gine before performing any main- tenance or checking procedures.
WARNING
The metallic parts reach high tem- peratures immediately after stop- ping the engine.
3. When replacing the cutting at- tachment or any other part, or
when replacing the oil or any lu- bricant, always be sure to use only KOMATSU ZENOAH prod- ucts or products which have been certified by KOMATSU ZENOAH for use with the KOMATSU ZENOAH product.
4.In the event that any part must be replaced or any maintenance or repair work not described in this manual must be performed, please contact a representative from the store nearest KOMATSU ZENOAH authorized servicing dealer for assistance.
5.Do not use any accessory or at- tachment other than those bear- ing the KOMATSU ZENOAH mark and recommended for the unit.
6.Under no circumstances should you ever take apart the product or alter it in any way. Doing so might result in the product be- coming damaged during opera- tion or the product becoming un- able to operate properly.
HANDLING FUEL |
|
1. The engine of the KOMATSU |
|
ZENOAH product is designed to |
|
run on a mixed fuel, which con- |
|
tains highly flammable gasoline. | G |
Never store cans of fuel or refill | B |
the tank of the unit in any place |
|
where there is a boiler, stove, |
|
wood fire, electrical sparks, weld- |
|
ing sparks, or any other source |
|
of heat or fire which might ignite |
|
the fuel. |
|
2.Never smoke while operating the unit or refilling its fuel tank.
3. When refilling the tank, always
turn off the engine and allow it to
cool down. Take a careful look
around to make sure that there are no sparks or open flames any- where nearby before refueling.
4.Wipe spilled fuel completely us- ing a dry rag if any fuel spillage occurs during refueling.
5.After refueling, screw the fuel cap back tightly onto the fuel tank and then carry the unit to a spot 3 m or more away from where it was refueled before turning on the en- gine.
TRANSPORTATION
1. When
2.Never transport the product over rough roads over long distances by vehicle without removing all fuel from the fuel tank. If doing so, fuel might leak from the tank dur- ing transport.