Set up | Zenoah BCZ3000DW specs

BCZ3000DL / BCZ3000DW

6. Set up

INSTALLING HANDLE (BC3000DL)

•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you.

1.Loosen the 4bolts on the upper cap and insert the handles equally. Retighten the bolts.

2.Put the handle assembly into the bracket and put the upper cap over it. Tighten the cap securely.

1.Remove the air cleaner cover.

2.Connect the end of the throttle wire to the joint on the top of the carburetor.

NOTE

•When installing the cleaner cover, make sure to put the high-tension wire in it.

•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.

PROTECTOR (BC3000DW)

•Wrap the protector around the outer pipe as shown in the figure, and fasten the hooks.

•Attach the debris guard with the bolts provided while inserting the spacer (A) between the guard and the pipe.

GB-8

1.While locking the gear shaft by inserting the supplied tool into the upper holder on the gear box, loosen and remove the bolt (left-handed).

2.Fit the line head assembly to the gear shaft by using bolt (A). Hand tighten it securely.

INSTALLING DEBRIS GUARD FOR METAL BLADE

•When using metal blade, make sure to remove the guard skirt.

1.Put the angled bar into the side holes of the inner holder and the gearcase.

2.Remove the blade bolt (Lefthanded) and the outer holder from the gearshaft.

3.Put the blade onto the inner holder. Make the marked side face the holder.

4.Put the outer holder onto the gearshaft making the recessed side face the blade.

5.Fasten the blade by the blade bolt with the spring washer and the bolt cover .

1.Put on strap and attach unit to strap.

2.Slide clamp up or down until unit balances with head aparting from the ground when using it.