Zenoah BC2310DL Adjusting Throttle Cable, Adjusting Idling Speed, Cutting Work Line Head Usage

BC2310DL

8. Operation

ADJUSTING THROTTLE CABLE

•The normal play is 1 or 2 mm when measured at the carburetor side end. Readjust with the cable adjuster as required.

.04 in
(1 ~ 2 mm)	(1)

(1) Cable adjuster

ADJUSTING IDLING SPEED

(1)Idle adjusting screw

1.When the engine tends to stop frequently at idling mode, turn the adjusting screw clockwise.

2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw counter-clockwise.

NOTE

• Warm up the engine before adjusting the idling speed.

CUTTING WORK (LINE HEAD USAGE)

WARNING

1.Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury.

2.Keep the cutting attachment guard in place at all times when the unit is operated.

TRIMMING GRASS AND WEEDS

•Always remember that the TIP of the line does cut- ting. You will achieve better results by not crowding the line into the cutting area. Allow the unit to trim at its own pace.

1.Hold the unit so the head is off the ground and is tilted about 20 degrees toward the sweep direction.

2.You can avoid thrown debris by sweeping from your left to the right.

3.Use a slow, deliberate action to cut heavy growth. The rate of cutting motion will depend on the material being cut. Heavy growth will require slower action than will light growth.

4.Never swing the unit so hard as you are in danger of losing your balance or control of the unit.

5.Try to control the cutting motion with the hip rather than placing the full workload on the arm and hands.

6.Take precautions to avoid wire, grass and dead, dry, long-stem weeds from wrapping around the head shaft. Such materials can stall the head and cause the clutch to slip, resulting in damage to the clutch system if repeated frequently.

ADJUSTING THE LINE LENGTH

•Your brush cutter is equipped with a semi- auto type nylon line head that allows the operator to advance the line without stopping the engine. When the line becomes short, lightly tap the head on the ground while running the engine at full throttle.

•Each time the head is bumped, the line advances about 25 mm. For better effect, tap the head on bear ground or hard soil. Avoid bumping in thick, tall grass as the engine may stall by overload.

GB-12