Zenoah CHT2300L, HT2300A, CHT2300B manual  8 

Page 10

Set up

CHT2300B/CHT2300L

1.Attach the engine to the clutch housing of the cutter unit. Casually fix the front 2 points with the screws(.55" long)(15mm long).

2.After connecting the ground wire, install the rear handle to the clutch housing with the screw(2" long)(50mm long) and the nut.

3.Put the screw(1.6" long)(40mm long) through the ground wire terminal and the rear handle, and in to the engine mounting base. Securely tighten all of the engine mounting screws.

4.Attach the front handle onto the gear housing and fasten with 2 screws(1.2" long)(30mm long) and nuts.

5.Connect the throttle cable with the lever on the rear handle, and secure the end with the hardware attached to the handle.

6.Check the cable play and, if necessary, adjust between .04" and .08" (1~2mm) by bending throttle wire receiver of the bracket with a nipper.

8

Image 10
Contents Owner / Operator Manual Safety First Contents Safety Precautions  2 Work Gear and Clothing Avoid Noise Problem Things to Check Before Using Your HEDGE-TRIMMERThings to Check Before Starting UP the Engine Things to be Careful about When Using Your HEDGE-TRIMMER  6  Set up HT2300A/HT2300L 8  Recommended Mixing Ratio Gasoline 32OIL HOW to MIX FuelFuel Fueling the UnitStarting Engine Warning OperationStopping Engine Adjusting Idling Speed HOW to USEMaintenance Spark Arrester MufflerIntake AIR Cooling Vent Warning Procedures to be Performed After Every 100 Hours of USE StorageSpecifications HT2300A HT2300L 16  Parts List  18   19   20   21   22   23   24   25  Manufacturers Warranty Coverage RedMax 2-YEAR Limited Warranty RedMax Garantie limitée à 2 ans Emission Control Label Engine Family 1KZXS CD EMKomatsu Zenoah America INC