Explanation of Symbols on the Machine | Zenoah G2500 OPS specs

G2500 / G2500 OPS

2. Explanation of Symbols on the Machine

WARNING

For safe operation and maintenance, symbols are carved in relief on the machine. According to these indications, please be careful not to make any mistake.

The port to refuel “MIX GASOLINE”

Position: Fuel cap

The port to top up chain oil

Position: Oil cap

Setting the switch to the “O” position, the engine stops immediately. Position: Front at the top of the rear handle

Starting the engine. If you pull out the choke knob (at the back-right of the rear handle) to the point of the arrow, you can set the starting mode as follows:

•First-stage position – starting mode when the engine is warm.

•Second-stage position – starting mode when the engine is cold. Position: Upper-right of the aircleaner cover

The screw under the “H” stamp is The High-speed adjustment screw. The screw under the “L” stamp is The Slow-speed adjustment screw. The screw at the left of the “T” stamp is the Idle adjustment screw.

Position: Left side of the rear handle

Shows the directions that the chain brake is released (white arrow) and activated (black arrow).

Position: Front of the chain cover

If you turn the rod by screwdriver follow the arrow to the "MAX" position, the chain oil flow more, and if you turn to the "MIN" position, less. Position: Bottom of the power unit

AA : Indicates the operation selecting position of the select lever for the One-push-start and Super e-START at a start of the recoil.

B : Indicates the operating direction of the select lever at a start of the engine by One-push-start.

B Position: Upper side portion of the recoil starter

GB-8