Zenoah G500AVS owner manual Maintenance After Each USE, Periodical Service Points

G455AVS / G500AVS

A log lying on the ground

Saw down halfway, then roll the log over and cut from the opposite side.

A log hanging off the ground

In area A, saw up from the bottom one-third and finish by sawing down from the top. In area B, saw down from the top one-third and finish by sawing up from the bot- tom.

Cutting the limbs of Fallen Tree

First check to which side the limb is bent. Then make the initial cut from the bent side and finish by sawing from the opposite side.

WARNING

•Be alert to the springing back of a cut limb. Pruning of Standing Tree

Cut up from the bottom, finish down from the top.

WARNING

•Do not use an unstable foothold or ladder.

•Do not overreach.

•Do not cut above shoulder height.

•Always use both your hands to hold the saw.

7. Maintenance

WARNING

•Before cleaning, the inspecting or repairing the unit, make sure that engine has stopped and is cool. Dis- connect the spark plug to prevent accidental starting.

■MAINTENANCE AFTER EACH USE

1. Air filter

Dust on the cleaner surface can be removed by tapping a corner of the cleaner against a hard surface. To clean dirt in the meshes, split the cleaner into halves and brush in gaso- line. When using compressed air, blow from the inside.

To assemble the cleaner halves, press the rim until it clicks.

NOTE

When installing the main filter, make sure that the grooves on the filter edge are correctly fit with the projections on the cylinder cover.

2. Oiling port

Dismount the guide bar and check the oiling port for clogging.

Oiling port

GB-12

3. Guide bar

When the guide bar is dismounted, remove sawdust in the bar groove and the oiling port.

Grease the nose sprocket from the feeding port on the tip of the bar.

	Grease port
Oiling port	Sprocket

4. Others

Check for fuel leakage and loose fastenings and damage to major parts, especially handle joints and guide bar mounting. If any defects are found, make sure to have them repaired before operating the saw again.

■PERIODICAL SERVICE POINTS

1. Cylinder fins

Dust clogging between the cylinder fins will cause overheat- ing of the engine. Periodically check and clean the cylinder fins after removing the air cleaner and the cylinder cover. When installing the cylinder cover, make sure that switch wires and grommets are positioned correctly in place.

NOTE

Be sure to block the air intake hole.