6. Set up
SE1
SE2
SE3
SE4
SE5
■MOUNTING ENGINE (SE1)
1.Loosen the bolts temporarily attached to the clutch housing.
2.Push the driveshaft toward the gearcase and rotate it by hand to check that the driveshaft is engaged with the gears.
3.Insert the shaft tube into the clutch housing until it bottoms. When difficult to engage, twist the engine slightly.
4.Align the positioning holes on the clutch housing and the shaft tube and fit the bolt into the holes. And fasten the tightning bolts by turns securely.
(Tightning torque: 4.9~7.8 N.m. (0.5~0.8kg·m))
(1)Positioning hole
(2)Bolt (M5x10)
(3)Tightning bolt (M5x22)
■INSTALLING HANDLE (SE2)
•Mount the handle to the shaft tube and clamp it at your best operating position.
■INSTALLING DEBRIS GUARD (SE3)
•Put the debris guard on the shaft tube near the gear box, attach it with the screw and nut provided.
■CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover. (SE4)
2.Connect the end of the throttle wire to the joint on the top of the carburetor. (SE5)
■CONNECTING SWITCH WIRES
•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.