Zenoah BT225 manual  14 , Recommended Mixing Ratio Gasoline 50OIL, HOW to MIX Fuel

Page 14

7. Fuel

WARNING

Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3m (10ft) away from the fueling point before starting the engine.

The RedMax engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use. If RedMax oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use. (JASO FC GRADE OIL or ISO EGC GRADE)

Do not use BIA or TCW (2-stroke water- cooling type) mixed oil.

14

RECOMMENDED MIXING RATIO GASOLINE 50:OIL 1

50:1 MIXING CHART

GASOLINE gal. 1 2 3 4 5

2-CYCLE OIL fl.oz 2.6 5.2 7.8 10.4 13

GASOLINE liter 1

2

3

4

5

2-CYCLE OIL ml 20 40 60 80 100

Exhaust emission are controlled by the fundamental engine parameters and components(eq., carburation, ignition timing and port timing) without addition of any major hardware or the introduction of an inert material during combustion.

These engines are certified to operate on unleaded gasoline.

Make sure to use gasoline with a minimum octane number of 89 RON (USA/Canada: 87AL)

If you use a gasoline of a lower octane value than prescribed, there is a danger that the engine temperature may rise and an engine problem such as piston seizing may consequently occur.

Unleaded gasoline is recommended to reduce the contamination of the air for the sake of your health and the environment.

Poor quality gasolines or oils may damage sealing rings, fuel lines or fuel tank of the engine.

HOW TO MIX FUEL

IMPORTANT

Pay attention to agitation.

1.Measure out the quantities of gasoline and oil to be mixed.

2.Put some of the gasoline into a clean, approved fuel container.

3.Pour in all of the oil and agitate well.

4.Pour In the rest of gasoline and agitate

Image 14
Contents BT225 Safety First Contents 3  SpecificationsParts location  4  Symbols on the machine  5 Working Circumstance For safe operationWorking Condition  6 Working Plan  7  8  Before Starting the EngineStarting the Engine Using the Product  9 Handling Fuel MaintenanceIf Someone Comes  10 Transportation  11 Set up  12 SE6 Installing Cutting Head SE6  13  14  HOW to MIX FuelFuel Recommended Mixing Ratio Gasoline 50OILFueling the Unit For Your Engine LIFE, Avoid 16  OperationOP1 OP2 OP3 OP4 Starting EngineLine Head Usage Adjusting Idling Speed OP5OP5 Stopping Engine Trimming Grass and WeedsAdjusting the Line Length  18  19  MaintenanceRefilling Trimming Line  20  Fuel Filter MA1 MA2 MA3AIR Filter Spark PlugMuffler MA4 22  Spark Arrester 23  Procedures to be Performed After Every 100 Hours of USEMA5 MA6 Check Probable Causes Action Troubleshooting guideStorage  24 Parts list  25 Drive Unit BT225 S/N 000001 and up  26  27  Engine Unit BT225 S/N 50100000 and up  28  29  Description Part Number Qty Key#Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC