Poulan PRRT65A manual To Adjust Throttle Control Cable See Fig, To Adjust Carburetor

Page 16

SERVICE AND ADJUSTMENTS

ENGINE

TO ADJUST THROTTLE CONTROL CABLE (See Fig. 27)

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, proceed as follows:

•With engine not running, move remote throttle control lever to “FAST” position.

•If throttle lever on engine touches high speed stop, no further adjustment is necessary. If throttle lever does not touch high speed stop, continue with adjustment procedure.

•Loosen cable clamp screw.

•Move throttle lever up until it touches high speed stop, and hold in this position.

•Tighten cable clamp screw securely.

FUELCLAMP

TANKSCREW

CASING

AND WIRE

THROTTLE

CONTROL

FIG. 27

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjust- ment should not be necessary. However, engine perfor- mance can be affected by differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, contact your nearest authorized service center/department

IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE T H E F A C T O R Y H I G H S P E E D S E T T I N G C A N B E DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR N E A R E S T A U T H O R I Z E D S E R V I C E C E N T E R / DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT A N D E X P E R I E N C E T O M A K E A N Y N E C E S S A R Y ADJUSTMENTS.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents PRRT65A Safety Rules Maintenance and StorageTraining PreparationTable of Contents Tools Required for Assembly AssemblyOPERATOR’S Position See Fig Install Handle See Figs , 4, Unpacking Carton See FigAttach Clutch Cable See Fig Connect Shift ROD See FigRemove Tiller from Crate Check Tire PressureOperation Meets Ansi Safety RequirementsKnow Your Tiller HOW to USE Your Tiller Tine Operation with Wheel DriveForward Wheels ONLY/TINES Stopped Reverse Wheels ONLY/TINES StoppedBefore Starting Engine TurningTo Transport ADD GasolineTilling Hints Tine Shear PinsCultivating Maintenance Schedule Lubrication ChartCustomer Responsibilities General RecommendationsAIR Filter See Fig EngineCooling System See Fig Cleaning Service and AdjustmentsTiller To Remove Belt Guard See Fig Ground Drive Belt Adjustment See FigTo Replace Ground Drive Belt See Fig Tine Replacement See Figs , 25, To Adjust Throttle Control Cable See Fig To Adjust CarburetorStorage OtherFuel System Engine OILTroubleshooting Points Handle Assembly Tiller Model Number PRRT65AMAINFRAME, Left Side KEY Part NO. NO. DescriptionMAINFRAME, Right Side Transmission Tine Shield Tine Assembly Decals Service Notes Limited Warranty Parts and Service
Top Page Image Contents