Poulan PRRT65A manual Table of Contents

Page 3

PRODUCT SPECIFICATIONS

GASOLINE CAPACITY:

3 Quarts (2.8L)

 

Unleaded Regular

OIL(API-SF-SJ) :

SAE 30 (Above 32°F/0°C)

(Capacity: 20 oz./0.6L)

SAE 5w-30(Below 32°F/0°C)

SPARK PLUG :

Champion

(GAP: .030"/0.76mm)

RC12YC

 

 

CONGRATULATIONS on your purchase of a new tiller. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problems you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this unit.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tiller properly. Always observe the “SAFETY RULES”.

CUSTOMER RESPONSIBILITIES

Read and observe the safety rules.

Follow a regular schedule in maintaining, caring for and using your tiller.

Follow instructions under “Customer Responsibilities” and “Storage” sections of this Owner’s Manual.

IMPORTANT: THIS UNIT IS EQUIPPED WITH AN INTERNAL COMBUSTION ENGINE AND SHOULD NOT BE USED ON OR NEAR ANY UNIMPROVED FOREST- COVERED, BRUSH-COVERED OR GRASS COVERED LAND UNLESS THE ENGINE'S EXHAUST SYSTEM IS EQUIPPED WITH A SPARK ARRESTER MEETING APPLICABLE LOCAL LAWS (IF ANY). IF A SPARK ARRESTER IS USED, IT SHOULD BE MAINTAINED IN EFFECTIVE WORKING ORDER BY THE OPERATOR.

IN THE STATE OF CALIFORNIA, A SPARK ARRESTER IS REQUIRED BY LAW (SECTION 4442 OF THE CALIFORNIA PUBLIC RESOURCES CODE). OTHER STATES MAY HAVE SIMILAR LAWS. FEDERAL LAWS APPLY ON FEDERAL LANDS. SEE YOUR AUTHORIZED SERVICE CENTER/DEPARTMENT FOR SPARK ARRESTER.

TABLE OF CONTENTS

SAFETY RULES

2

PRODUCT SPECIFICATIONS

3

ASSEMBLY

4-6

OPERATION

7-10

MAINTENANCE SCHEDULE

11

CUSTOMER RESPONSIBILITIES

3,11-13

SERVICE & ADJUSTMENTS

13-16

STORAGE

17

TROUBLESHOOTING

18

REPAIR PARTS-TILLER

19-25

WARRANTY

27

3

Image 3
Contents PRRT65A Preparation Safety RulesMaintenance and Storage TrainingTable of Contents Assembly Tools Required for AssemblyOPERATOR’S Position See Fig Unpacking Carton See Fig Install Handle See Figs , 4,Check Tire Pressure Attach Clutch Cable See FigConnect Shift ROD See Fig Remove Tiller from CrateMeets Ansi Safety Requirements OperationKnow Your Tiller Reverse Wheels ONLY/TINES Stopped HOW to USE Your TillerTine Operation with Wheel Drive Forward Wheels ONLY/TINES StoppedADD Gasoline Before Starting EngineTurning To TransportTine Shear Pins Tilling HintsCultivating General Recommendations Maintenance ScheduleLubrication Chart Customer ResponsibilitiesEngine AIR Filter See FigCooling System See Fig Service and Adjustments CleaningTiller Ground Drive Belt Adjustment See Fig To Remove Belt Guard See FigTo Replace Ground Drive Belt See Fig Tine Replacement See Figs , 25, To Adjust Carburetor To Adjust Throttle Control Cable See FigEngine OIL StorageOther Fuel SystemTroubleshooting Points Tiller Model Number PRRT65A Handle AssemblyKEY Part NO. NO. Description MAINFRAME, Left SideMAINFRAME, Right Side Transmission Tine Shield Tine Assembly Decals Service Notes Limited Warranty Parts and Service