Poulan FN620L owner manual To Replace V-BELT See Fig, To Adjust Carburetor

Page 15

SERVICE AND ADJUSTMENTS

TO REPLACE V-BELT (See Fig. 23)

Replace V-belt if it has stretched considerably or if it has cracks or frayed edges.

Belt guard must be removed to service belt. See “TO RE- MOVE BELT GUARD” in this section of manual.

BELT REMOVAL

•Remove V-belt from transmission pulley first and then from engine pulley.

BELT REPLACEMENT

•Install new V-belt to engine pulley first then to trans- mission pulley. Be sure belt is positioned on inside groove of both pulleys, inside all belt guides and rests on idler pulley.

CHECK TINE OPERATION

•See “TINE OPERATION CHECK” in this section of manual.

REPLACE BELT GUARD

BELT

GUIDE

ENGINE PULLEY

TRANSMISSION

PULLEY

BELT

GUIDE

V-BELT

IDLER

PULLEY

FIG. 23

ENGINE

TO ADJUST CARBURETOR

The carburetor has a high speed fixed jet and has been preset at the factory and adjustment should not be nec- essary. However, minor adjustments may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, see engine manual.

IMPORTANT: NEVER TAMPER WITH THE ENGINE

GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE

SPEED. OVERSPEEDINGTHE ENGINE ABOVETHE FACTORY

HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK

THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,

CONTACTYOUR NEAREST AUTHORIZED SERVICE CENTER/

DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND

EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Model NO. FN620L Preparation Safety RulesMaintenance and Storage TrainingTable of Contents Assembly Tools Required for AssemblyContents of Hardware Pack Tilling Width Unpack Carton & Install Handle See FigInstall Depth Stake Assembly See Fig Handle HeightMeets Ansi Safety Requirements OperationKnow Your Tiller Tilling HOW to USE Your TillerStopping See Fig Tine Operation See FigTo Start Engine See Fig Before Starting EngineFill Engine with OIL See Fig ADD GasolineBreaking in Your Tiller Tilling HintsCultivating Before Each USE MaintenanceLubrication Chart General RecommendationsEngine AIR Cleaner See FigTransmission CleaningMuffler Spark PlugTine Arrangement Service and AdjustmentsTo Adjust Handle Height See Fig TillerFinal Check on Position Tine Operation Check See FigTo Remove Belt Guard See Fig Final Check OFF PositionTo Replace V-BELT See Fig To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsKEY Part Description Handle AssemblyTiller - Model Number FN620L KEY Part NO. NO. Description12000036 Belt Guard and Pulley AssemblyWheel and Depth Stake Assembly 9194R Pin, Clevis9186R Wheel Tineipb4 Tine AssemblyTransmission 73900600187912 Decals 189783189784 Limited Warranty
Top Page Image Contents