Poulan FN620L Tine Operation Check See Fig, To Remove Belt Guard See Fig, Final Check on Position

Page 14

SERVICE AND ADJUSTMENTS

NOTE: Additional tine arrangements can be attained by moving outer tines to opposite side of tiller which will point tines outward. Always keep sharp edges of tines rotating forward from above.

TINE OPERATION CHECK (See Fig. 21)

Be sure tines do not rotate when engine is running and tine control is in the “OFF” position.

WARNING: Disconnect spark plug wire from spark plug to prevent starting while checking tine operation.

FINAL CHECK “OFF” POSITION

•With tine control “OFF” (up), push down on handle to raise tines off the ground.

•Slowly pull recoil starter handle while observing tines. Tines should not rotate.

•If tines rotate, place loop of idler spring in a lower link of chain and retest.

FINAL CHECK “ON” POSITION

•With tine control “ON” (held down to handle) push down on handle to raise tines off the ground.

•Slowly pull recoil starter handle while observing tines. Tines should rotate forward.

•If tines do not rotate, place loop of idler spring in a higher link of chain and retest.

NOTE: If “ON” position check required adjustment, recheck “OFF” position adjustment to insure tines do not rotate when control is “OFF” (up).

TINE CONTROL “OFF” POSITION

TINE CONTROL “ON” POSITION

CHAIN

IDLER

SPRING

TO REMOVE BELT GUARD (See Fig. 22)

•Remove screws from side of belt guard.

•Pull belt guard out and away from unit.

•Replace belt guard by reversing above procedure. Be sure slot in bottom of belt guard is under head of tine shield bolt and all nuts are tightened securely.

BELT GUARD

SCREW

SCREW

TINE

SHIELD

SCREW

FIG. 22

FIG. 21

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Model NO. FN620L Training Safety RulesMaintenance and Storage PreparationTable of Contents Contents of Hardware Pack AssemblyTools Required for Assembly Handle Height Unpack Carton & Install Handle See FigInstall Depth Stake Assembly See Fig Tilling WidthKnow Your Tiller Meets Ansi Safety RequirementsOperation Tine Operation See Fig HOW to USE Your TillerStopping See Fig TillingADD Gasoline Before Starting EngineFill Engine with OIL See Fig To Start Engine See FigCultivating Breaking in Your TillerTilling Hints General Recommendations MaintenanceLubrication Chart Before Each USEAIR Cleaner See Fig EngineSpark Plug CleaningMuffler TransmissionTiller Service and AdjustmentsTo Adjust Handle Height See Fig Tine ArrangementFinal Check OFF Position Tine Operation Check See FigTo Remove Belt Guard See Fig Final Check on PositionTo Adjust Carburetor To Replace V-BELT See FigFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionKEY Part NO. NO. Description Handle AssemblyTiller - Model Number FN620L KEY Part DescriptionBelt Guard and Pulley Assembly 120000369186R Wheel Wheel and Depth Stake Assembly9194R Pin, Clevis Tine Assembly Tineipb4187912 Transmission73900600 189784 Decals189783 Limited Warranty
Top Page Image Contents