Poulan 190388 owner manual Safety Rules, Training, Preparation, Operation, Maintenance and Storage

Page 2

SAFETY RULES

SAFE OPERATION PRACTICES FOR WALK-BEHIND POWERED ROTARY TILLERS

TRAINING

Read the Owner’s Manual carefully. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly.

Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction.

Keep the area of operation clear of all persons, par- ticularly small children, and pets.

PREPARATION

Thoroughly inspect the area where the equipment is to be used and remove all foreign objects.

Disengage all clutches and shift into neutral before starting the engine (motor).

Never operate the tiller without proper guards, plates, or other safety protective devices in place.

Keep children and pets away.

Do not overload the machine capacity by attempting to till too deep at too fast a rate.

Never operate the machine at high speeds on slippery surfaces. Look behind and use care when backing.

Never allow bystanders near the unit.

Use only attachments and accessories approved by the manufacturer of the tiller.

Never operate the tiller without good visibility or light.

Be careful when tilling in hard ground. The tines may catch in the ground and propel the tiller forward. If this occurs, let go of the handlebars and do not restrain the machine.

Do not operate the equipment without wearing ade- quate outer garments. Wear footwear that will improve footing on slippery surfaces.

Handle fuel with care; it is highly flammable.

Use an approved fuel container.

Never add fuel to a running engine or hot engine.

Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors.

Replace gasoline cap securely and clean up spilled fuel before restarting.

Use extension cords and receptacles as specified by the manufacturer for all units with electric drive motors or electric starting motors.

Never attempt to make any adjustments while the engine (motor) is running (except where specifically recommended by manufacturer).

OPERATION

Do not put hands or feet near or under rotating parts.

Exercise extreme caution when operating on or cross- ing gravel drives, walks, or roads. Stay alert for hidden hazards or traffic. Do not carry passengers.

After striking a foreign object, stop the engine (motor), remove the wire from the spark plug, thoroughly inspect the tiller for any damage, and repair the damage before restarting and operating the tiller.

Exercise caution to avoid slipping or falling.

If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.

Stop the engine (motor) when leaving the operating position.

Take all possible precautions when leaving the machine unattended. Disengage the tines, shift into neutral, and stop the engine.

Before cleaning, repairing, or inspecting, shut off the engine and make certain all moving parts have stopped. Disconnect the spark plug wire, and keep the wire away from the plug to prevent accidental starting.Disconnect the cord on electric motors.

Do not run the engine indoors; exhaust fumes are dangerous.

MAINTENANCE AND STORAGE

Keep machine, attachments, and accessories in safe working condition.

Check shear pins, engine mounting bolts, and other bolts at frequent intervals for proper tightness to be sure the equipment is in safe working condition.

Never store the machine with fuel in the fuel tank inside a building where ignition sources are present, such as hot water and space heaters, clothes dryers, and the like. Allow the engine to cool before storing in any enclosure.

Always refer to the operator’s guide instructions for important details if the tiller is to be stored for an ex- tended period.

- IMPORTANT -

CAUTIONS, IMPORTANTS, AND NOTES ARE A MEANS OF ATTRACTING ATTENTION TO IMPORTANT OR CRITICAL INFORMATION IN THIS MANUAL.

IMPORTANT: USED TO ALERT YOU THAT THERE IS A POSSIBILITY OF DAMAGING THIS EQUIPMENT.

NOTE: Gives essential information that will aid you to better understand, incorporate, or execute a particular set of instructions.

Look for this symbol to point out im- portant safety precautions. It means CAUTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED.

CAUTION: Always disconnect spark plug wire and place wire where it can- not contact spark plug in order to pre- vent accidental starting when setting up, transporting, adjusting or making repairs.

WARNING

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproduc- tive harm.

2

Image 2
Contents Model NO. HDR500M Training Safety RulesMaintenance and Storage PreparationTable of Contents OPERATOR’S Position See Fig AssemblyTools Required for Assembly Install Handle See Figs , 4, Unpacking Carton See FigRemove Tiller from Crate Attach Clutch Cable See FigConnect Shift ROD See Fig Check Tire PressureKnow Your Tiller Meets Ansi Safety RequirementsOperation FORWARD- Wheels ONLY/TINES Stopped HOW to USE Your TillerTine Operation with Wheel Drive Reverse Wheels ONLY/TINES StoppedTo Transport Before Starting EngineTurning ADD GasolineTo Start Engine See Fig Tilling HintsCultivating Tine Shear PinsAdjust Wheels for Cultivating See Figs General Recommendations MaintenanceMaintenance Schedule Engine AIR Filter See FigSpark Plug CleaningMuffler Cooling System See FigTiller Service and AdjustmentsTo Adjust Handle Height See Fig Tire CareTine Replacement See Figs , 25 To Replace Ground Drive Belt See Figs Ground Drive Belt Adjustment See FigTo Remove Belt Guard See Fig To Adjust Throttle Control Cable See Fig To Adjust CarburetorFuel System StorageOther Engine OILTroubleshooting Points Limited Warranty

190388 specifications

The Poulan 190388 is a powerful and versatile tool designed to meet the demands of homeowners and landscaping professionals alike. Renowned for its dependability and performance, this lawn care equipment stands out in the market for several compelling reasons.

One of the main features of the Poulan 190388 is its robust 42cc engine. This two-cycle engine delivers ample power to tackle a variety of yard tasks ranging from trimming lawns to enhancing garden aesthetics. Its design prioritizes efficiency, ensuring that users can complete their tasks without frequent interruptions for refueling.

The Poulan 190388 is equipped with a specially designed cutting system that ensures precision and efficiency. Its 18-inch cutting blade guarantees optimal coverage and reduces the time needed for mowing or trimming. The sharp edge of the blade allows for a clean cut, promoting healthier grass growth and enhancing the overall appearance of the lawn.

A significant advantage of this tool is its lightweight design. Weighing approximately 10 pounds, the Poulan 190388 is easy to maneuver, making it an ideal choice for users of all experience levels. Its ergonomic handle offers a comfortable grip, allowing prolonged use without causing fatigue, thereby increasing productivity during long work sessions.

The Poulan 190388 incorporates advanced technologies, including an easy-start mechanism that reduces the resistance typically associated with starting two-cycle engines. This feature ensures that the equipment can be fired up easily, even for users who may not have extensive experience with lawn care tools.

Durability is another hallmark of the Poulan 190388. Constructed from high-quality materials, this lawn care equipment is designed to withstand the wear and tear of regular use. Its robust build not only enhances its lifespan but also decreases the likelihood of maintenance issues, allowing users to focus more on their lawn care tasks rather than repairs.

Additional features of the Poulan 190388 include adjustable cutting heights, allowing users to tailor the height of their cut according to their specific needs. This flexibility makes it suitable for various grass types and terrains, ensuring that it meets diverse landscaping demands.

In summary, the Poulan 190388 stands out for its powerful engine, lightweight design, innovative technologies, and robust durability. Whether for maintaining a manicured lawn or tackling rough terrain, it proves to be an essential tool for achieving a beautiful landscape. With its combination of efficiency and user-friendly features, the Poulan 190388 is a smart investment for anyone looking to elevate their lawn care game.