Simplicity 1693207, 1693705, 1693704 manual Starting and Stopping the Engine, To Start Engine

Page 17

STARTING AND STOPPING THE ENGINE

To Start Engine:

1.Drive control levers should be released to neutral position.

2.Turn fuel shut-off valve (if equipped) 1/4 turn to open.

3.Push choke lever to choke position.

4.Move throttle control lever to fast position.

5.Push rocker switch (if equipped) to on.

6.Pull start engine. Stand to the right of tiller engine, grasp rope handle and pull rope out, slowly, until it pulls slightly harder. Let rope rewind slowly.Then pull rope with a rapid full arm stroke. Let rope return to starter slowly. Let engine warm for a few minutes before beginning to operate.

7.When engine starts, operate in fast position.

8.Move choke lever toward run position.

NOTE: If engine does not start after 3 pulls, check troubleshooting guide for suggestions.

To Stop Engine:

1.Move throttle control to slow position. Then move to stop position.

2.Push rocker switch (if equipped) to off.

3.Close fuel shut-off valve (if equipped).

Refer to your engine manual for further information.

Operation

CAUTION

Always keep hands and feet clear of rotating machine parts.

CAUTION

Temperature of muffler and near by areas may exceed 150° F. Avoid these areas.

CAUTION

Do not move choke lever to CHOKE to stop engine. Backfire or engine damage may occur.

To stop the engine at any time, move throttle control to the off position. To stop wheels and tines at any time, release drive control levers to neutral position.

Page 13

Image 17
Contents How to use this file...Operators Manuals This page Intentionally Blank OPERATOR’S Manual Page Table Of Contents Section Checklist Operation SafetyImportant Safety Instructions Owners ResponsibilityOperation Safety Decals Safety Signs & DecalsModel 616RT Drive Control Levers ControlsEngages wheels and tines in reverse Reverse Handle 616RTThrottle Control Engine ControlsWheel Lockouts 514RT AdjustmentsWheel Lockouts 616RT Handlebar Adjustments 514RT Handlebar Adjustments 616RTDrag Stake Belt Tension AdjustmentPRE-START Inspection OperationTo Start Engine Starting and Stopping the EngineTilling Cultivating Tips TipsTilling Tips Check Forward Belt Tension Maintenance and StorageChange FORWARD/REVERSE Belt Check or Fill Engine Crankcase Lubrication Check Tiller Transmission GreaseCheck Tire Pressure Clean Tine Axle Shaft Engine MaintenancePrepare for Storage Tiller and Engine Maintenance ScheduleProblem REMEDY/ACTION Troubleshooting and RepairTroubleshooting Guide Troubleshooting and Repair Technical Manual Availability SpecificationsFeatures