Montgomery Ward TMO-39084A, TMO-39083A manual RSOl~1J

Wheel Chain

Case Pulley

/ 1-1

< ...~	If,~ "J/-
	~	-~	~'
	'~		: -;')
			'",.
~~,"'~- -- .'-\~
Reverse	Drive	I)

Small I

Pulle

L

Wheel Chain

Case Pulley Forward

.~veBelt

rSOl~1J

'"

6)

{2)\~~ ~L

~J;~					-'"			-\-
						--:::c:;:
				"	I Two-Step		Forward
							Engine	Pulley
					Engine	Pulley
FIGURE 23.							FIGURE 25.
							Reassemble new belts, following instructionsin
To remove the forward drive belt, proceed as							reverse order.
follows.
A.	Loosen (do		not remove)		the hex nut at the		IMPORTANTWhen
	top of the wire belt keeper.						reassembling belts,	be certain
B.	Pull	bottom	of wire	belt keeper		out and
							belts are routed around all belt
	then	upward,	pivoting	it	away from the for-		keeper pins as shown in figure 26.
	ward engine pulley. See figure 24.

FIGURE 24.

Lift belt off the forward engine pulley. See figure 25.D.

Remove belt from inside sheave of wheel chain case pulley.

--)tr'~13C4..

NOTE

Upon reassembly, refer to illustra- tion on page 18 for correct assembly

of wire belt guard for your modeltiller.