F | Montgomery Ward TMO-39083A, TMO-39084A specs

6. Secure drive clutch lever to weld bolt with rub- ber washer (T), flat washer (U) and hex lock nut.,(V).

See figure 13. Tighten hex nut.

7. Place the drive clutch lever in the neutral (N)

position. Adjust the cables at the cable bracket so that the cables are tight, then tighten the hex nuts against the cable

bracket.

IMPORTANT

Service engine with oil and gasoline before checking the drive clutch adjustment. Refer to the separate engine manual packed with your tiller.

8. Check the adjustment of the drive clutch as follows. Place the unit against a solid object

FIGURE 13.(wall, fence, etc.). With the tine clutch lever released and the drive clutch lever in the neutral position, carefully start the engine. If the unit shows any signs of motion with the drive clutch lever in neutral, shut the engine off immediately and readjust the hex nuts at the cable bracket. Recheck the adjustment as necessary .

9. Secure the cables to the handles as with cable ties (L). Cut off excess ends of cable ties.

CONTROLS-Location

and Use

Throttle Control

The throttle control lever is located on the right hand side of handle panel and controls the engine speed. See figure 14.

1.Start-Push throttle control lever forward (down) to start position.

2.Stop-Pull lever back (upward) to stop the engine.

Tine

Clutch

Lever

Throttle	Drive
Throttle	Clutch
Control	Lever
	O\
"0	,"

\ 'f

\'\O~

FIGURE 14.

Tine Clutch Lever

The tine clutch lever is located on the left handle. See figure 14.

Squeeze the lever down to engage the tines. Release the lever to disengage the tines.

Drive Clutch Lever

The drive clutch lever is located on the left hand side of handle panel. See figure 14.

The drive clutch lever may be placed in one of three positions.

1.Forward (F)-Move the drive clutch lever to the left and all the way forward to engage the drive mechanism to the wheels.

2.Neutral (N)-Move lever to the detent marked "N". Be certain lever is in neutral position when starting the engine.

3.Reverse (R)-Raise up on the handles to lift the tines out of the ground and pull the drive clutch lever back (upward) slowly to obtain reverse. Always use caution when using the reverse. When using reverse, if gear shift lever is released it will snap back into neutral (N).