Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information

Installing the NPE-G1 or NPE-G2

Caution Do not remove a USB Flash memory module when a read or write operation to the USB Flash memory module is in progress. The router might reload, or the USB Flash memory module can be damaged.

Note Only Cisco USB Flash memory modules and the Aladdin USB eToken Pro key are supported by Cisco routers.

Figure 7-8 Connecting a USB Flash Memory Module to a Router USB Port

 

FE

 

LINK

 

U

 

S

 

B

FOR

 

ONLY

138993

 

Note For detailed information about the Cisco IOS commands that support USB Flash memory modules, see the Cisco USB eToken and USB Flash Features Support document.

Go to the “Inserting the NPE-G1 or NPE-G2 into the Router” section on page 7-28for instructions on installing the NPE-G1 or NPE-G2 in the chassis.

Installing an SFP Module—NPE-G2

Note The SFP module is a separately orderable part and ships installed in your NPE-G2. However, if you are adding a SFP module, you must install the SFP module before you connect the cables to it. We strongly recommend cleaning optical cable connectors before connecting them to the SFP modules. See the “Fiber Optic Cleaning Information” section on page 7-67.

Network Processing Engine and Network Services Engine Installation and Configuration

7-20

OL-4448-12

 

 

Page 106
Image 106
Cisco Systems NPE-225, NPE-175 Installing an SFP Module-NPE-G2, Connecting a USB Flash Memory Module to a Router USB Port