Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information

Enabling the Second Processor on the NPE-G1

Upgrade the ROMmon. (The minimum ROMmon version is 12.3-4r.T3.)

Install the enabling software.

Instructions for upgrading ROMmon are in the “Using the upgrade rom-monitor file Command” section on page 7-64.

The minimum software release for the Broadband L2TP Access Concentrator (LAC), L2TP Network Server (LNS), and PPP Terminated Aggregation (PTA) is Cisco IOS Release 12.3(14)YM.

Also see the MPF for Broadband LAC, LNS, and PTA document for minimum memory requirements and configuration information.

Note Before enabling the second processor, you must have IP routing turned on.

Processor 1 is enabled by default after you install the enabling software. To have all packets forwarded by processor 0, use the no ip mpf command. To enable processor 1, use the ip mpf command.

Save the running configuration to NVRAM. See the “Copying the Saved Configuration to NVRAM” section on page 7-52. If you do not save the configuration settings that you created in the router using configuration mode and the setup facility, your configuration will be lost the next time you reload the router.

Error Messages

The following error messages are displayed if a feature is configured that is not supported in the MPF path:

Router# %MPF-4-IGNOREDFEATURES: Interface Gi0/3: Input "PBR" configurations are not MPF

supported and are IGNORED. %SYS-5-CONFIG_I: Configured from console by console

Router# (config-if)# %MPF-4-IGNOREDFEATURES: Interface Gi0/3: Input "PBR" configurations are not MPF supported and are IGNORED.

%MPF-4-IGNOREDFEATURES: Interface Gi0/3: Output "NetFlow" configurations are not MPF supported and are IGNORED.

Using show Commands Associated with the mpf Command

There are a variety of show commands associated with the mpf command. They are listed below along with sample output. Use these commands to verify the mpf installation.

Using the show interface stats Command, page 7-48

Using the show ip interface Command, page 7-48

Using the show mpf cpu Command, page 7-49

Using the show mpf cpu history Command, page 7-49

Using the show mpf interface Command, page 7-50

Using the show mpf ip exact-route Command, page 7-51

Using the show mpf punt Command, page 7-51

Using the show version Command, page 7-51

Network Processing Engine and Network Services Engine Installation and Configuration

 

OL-4448-12

7-47

 

 

 

Page 133
Image 133
Cisco Systems NPE-175, NPE-225 manual Error Messages, Using show Commands Associated with the mpf Command