Cisco Systems NPE-175, NPE-225 manual Reconnecting AC-Input Power to the Cisco uBR7246VXR Router

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information

Installing the NPE-G1 or NPE-G2

Reconnecting AC-Input Power to the Cisco uBR7246VXR Router

Figure 7-25 Connecting AC-Input Power to a Cisco uBR7246VXR Router

1

2

3

4

6

5

66422

1	Cable-retention clip	4	AC power cable
2	Power receptacle	5	Power switch
3	Captive installation screw	6	Handle

To reconnect AC-input power to a Cisco uBR7246VXR router, complete the following steps:

Step 1 At the rear of the router, check that the power switch on the power supply is in the off (O) position. Step 2 Slide the cable-retention clip to the left away from the AC receptacle, and plug in the power cable.

Step 3 Secure the cable in the power supply AC receptacle by sliding the cable-retention clip to the right until it snaps around the connector. The cable-retention clip provides strain relief for the AC power cable.

Step 4 Plug the AC power supply cable into the AC power source.

Note For the Cisco uBR7200 series routers, each AC-input power supply operating at 120 VAC requires a minimum of 7A service.

We recommend powering the Cisco uBR7200 series routers from a 120 VAC, 15A receptacle

U.S. (240 VAC, 10A international) at the power source.

Step 5 Repeat Step 1 through Step 4 if a second power supply is installed.

This completes the steps for reconnecting AC-input power to a Cisco uBR7246VXR router. Proceed to the “Powering Up the Router” section on page 7-45.

Network Processing Engine and Network Services Engine Installation and Configuration

OL-4448-12 7-37