Buhler FK366 warranty Field Operation contd

Page 16

45 Series Rotary Tiller

FIELD OPERATION - cont'd.

7.Align the unit with the working area.

8.Starting machine:

a.Run the engine at low idle.

b.Slowly engage the PTO control to start the machine.

c.Slowly bring the engine to the rated PTO speed. Never exceed rated speed.

d.Lower the machine to the ground and proceed down the field.

9.Stopping machine:

a.Slowly decrease engine speed to low idle.

b.Raise machine out of the ground.

c.Disengage PTO clutch slowly.

CAUTION: Place all controls in neutral, lower machine, stop engine, set park brake remove ignition key and wait for all moving parts to stop before dismounting.

10.Ground Speed:

Travel speed can vary between 2 and 5 mph (3 and 8 km/h) depending on the soil and terrain conditions. It is the responsibility of the operator to note the condition of the job being done and set the speed to obtain a quality tilling job and maintain control of the machine.

The speed can be increased to optimize tilling.

Decrease speed if you want the soil worked to a finer texture.

11.Operating hints:

a.Determine the moisture content of the soil before starting. Soil that is too wet will "ball-up" in the rotor blades making tilling impossible. Sandy soils normally can be worked better than heavy clay or loam soils. It is the responsibility of the operator to determine the soil type and moisture content before starting. It may be necessary to wait for the soil to dry out before starting to work.

b.Set the length of the Top Link to obtain the quality of the job desired without needlessly using power and fuel in churning the soil. Use the condition of the seedbed as your guide.

c.When tilling hard or compacted soils, it is recommended that two passes be used when working. Use the Depth Gauge Shoes on each side of the frame to adjust the tilling depth of the machine. The second pass should be made at an angle to the first to give a consistent job and minimize compaction.

d.Always remove heavy crop cover, all grass and weeds, before starting to prevent rotor plugging.

15

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Table of Contents Description Warranty Labor Warranty ClaimsImportant Facts Introduction Safety Think SAFETY! Work SafelyGeneral Safety Operating SafetyMaintenance Safety Transport SafetyStorage Safety Safety SignsSafety Sign Locations How to Install Safety signsWork Safely Safety Sign Locations cont’d Operation To the NEW Operator or Owner Machine ComponentsPRE-OPERATION Checklist Machine BREAK-INHorsepower vs. Width Equipment MatchingPoint Hitch Load Sensing HydraulicsDriveline Dimension Driveline Dimension Contd ATTACHING/UNHOOKING Field Operation Field Operation contd Field Operation contd Speed vs. weight Ratio TransportingStorage Fluids and Lubricants Service and MaintenanceGreasing Servicing Intervals Hours or once a seasonServicing Intervals cont’d Hours AnnuallyFrame Adjustment MaintenanceTine Replacement Clutch Maintenance Slip ClutchTrouble Shooting Problem Cause SolutionAssembly English Torque Specifications Bolt TorqueSeries Tiller Series Rotary Tiller Parts List When Ordering Parts Item # DescriptionAdjustment Mount Bracket Page Series Tiller Gearbox #906913 Series Rotary Tiller Series Tiller PTO Parts List Quantity Bundle Required Number Shipping BundlesTiller c/w PTO
Top Page Image Contents