
NOTE
If driveline is the correct length, omit the following steps “G” through “J” and proceed to step “K”.
G. Clamp driveline in a well padded vice to pre- vent damage to the shield. Cut off shield where marked. (Figure
Figure
H. Using cut off section of shield as a guide, cut shaft the same amount. (Figure
Figure
I. Repeat steps “G” and “H” to other driveline section.
J. Deburr ends of driveline sections and clean away all chips and fillings. (Figure
K. Apply
DANGER
MAKE CERTAIN DRIVELINE YOKES ARE SECURELY FASTENED. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY.
Figure
L. Adjust lower lift arm to level tiller right to left. Refer to tractor operator’s manual for instructions.
M. Adjust top link of tractor
N. Set up tractor stabilizer bars, sway blocks, or equivalent to prevent implement side sway. (Figure
Figure
Stabilizer Bars
Stabilizer
Lift Arms
Stabilizer
8