Land Pride | Table of Contents |
Section 1 Assembly and Set-Up
Hitch and Driveline Guard
Refer to Figure 1-1:
1.Install both top
2.Install spacer (#9) between upper
3.Securely tighten all bolts. Refer to the Torque Values Chart in the “Appendix” section on page 27.
4.Install driveline guard (#10) to the top of the
NOTE: Remove driveline guard for easier access to the driveline at the gearbox.
Leg Stand Assembly
Refer to Figure
1.Insert leg stand (#13) into leg stand holder on the end of the tiller frame.
2.Adjust to the desired height and pin with 1/4” x 1 3/4” long wire lock pin (#14).
IMPORTANT: The three upper holes are used for parking the tiller and the bottom hole is used when the tiller is in use.
Tractor Hook-Up
Refer to Figure
1.When using tractors with
2.Back tractor up to tiller until lower
3.Secure the tractor’s
4.Secure the tractor’s top link to the tiller top hitch using a 3/4" diameter hitch pin (supplied by customer). Adjust tractor top link in order to level the tiller.
5.Adjust the tractor’s
!WARNING
Lifting unit more than 14” high while PTO is engaged may damage driveline components.
10134 |
22191 |
Tractor
Figure
5/05/06 | RTA10 & RTA15 Series Rotary Tillers | 9 |