SECTION 3 – MAINTENANCE
3.4SERVICE – EVERY 50 OPERATING HOURS (CONT.)
3.4.3.Check Drive Clutch
1.Start engine and shift transmission to Forward.
2.Release park brake. Clutch should have no tendency to grab or cause motion.
3.Gradually increase engine speed with the accelerator pedal. The machine should begin to move slowly with no jerking or unusual noises.
4.If the clutch is not functioning smoothly or is dragging, it may require cleaning and lubrication. Contact local Snapper dealer for assistance.
IMPORTANT – DRIVE CLUTCH MAINTENANCE IS RECOMMENDED EVERY 200 HOURS OR YEARLY. MORE FREQUENT SERVICE INTERVALS MAY BE REQUIRED IN SEVERE APPLICATIONS. ALWAYS KEEP RUBBER DUST PLUG IN PLACE ON CLUTCH.
3.4.4.Change Engine Oil
Change engine oil as indicated by ServiceMinder display. Refer to oil changing instructions earlier in this section.
3.5SERVICE – EVERY 100 OPERATING HOURS
3.5.1.Change Engine Oil Filter
Change engine oil filter. Refer to engine manual for instructions and filter specifications.
3.6SERVICE – EVERY 200 OPERATING HOURS
(OR YEARLY)
3.6.1.Perform all maintenance required after 50 hours of operation. Refer to Section “Service – Every 50 Operating Hours”.
3.6.2.Change Transmission Fluid
1.Remove drain plug located on left bottom side of transmission case. Drain fluid into 6 quart minimum capacity pan. See Figure 3.6.
TRANSMISSION
FLUID DRAIN
PLUG
FIGURE 3.6
2.Allow fluid to drain completely. Reinstall drain plug and tighten securely.
3.Fill transmission with 5.6 qt of MOBILFLUID 424 or equivalent.
4.Check fluid level and top off as needed. Do Not over fill.
3.6.3.Replace Fuel Filter
1.Engine must be cool before proceeding.
2.Remove clamps from filter.
3.Remove hose from fittings on filter. Be prepared to collect small amount of fuel as it drains from the hose.
4.Dispose of old filter. Do Not attempt to clean and
5.Slide hose over fittings on new filter.
6.Reposition clamps over fittings on filter.
7.Clean up any spilled fuel.
8.Start engine and check for leaks.
WARNING
Gasoline is an extremely flammable liquid and its vapors are highly explosive. Handle only outdoors in an open, well ventilated area where vapor can dissipate safely and away from all sources of ignition.
3.7STORAGE (OUT OF SEASON)
3.7.1.Perform all maintenance as specified in the “Maintenance Schedule” in this manual and in the Engine Owners Manual.
1.Drain Fuel Tank. Drain fuel into approved container and store away from source of ignition.
2.Run Engine to empty carburetor bowl.
3.Remove Battery.
4.Charge Battery (if necessary – see Adjustments and Repairs, Battery) and store in cool dry place on a
5.Store the machine in a cool, dry, protected place.
253