DeVillbiss Air Power Company D25572 warranty To Start the Engine, Recoil start/Pull start

Page 13

Engine speed has been factory set to provide safe operation. Tampering with the engine speed adjustment could result in over-

heating of attachments and could cause a fire. Never attempt to “speed-up” the en- gine to obtain more performance. Both the output voltage and frequency will be thrown out of standard by this practice, endangering attachments and the user.

You MUST unplug any load from the generator before starting to prevent permanent damage to any appliances.

TO START THE ENGINE

(Recoil start/Pull start)

Never run engine indoors or in enclosed, poor ventilated areas, engine exhaust contains carbon monoxide, an

odorless and deadly gas.

1.Open the fuel shut-off valve. Turn counter clockwise until the valve stops. See Figure 8.

2.(if equipped) On the engine there is a ON/OFF switch located on the front panel of the engine. Place this switch to the "ON" position.

OR

Figure 8

3.Move the choke control located on the engine to "CHOKE" position. NOTE: No choke is required on warm engines. Make sure choke is in the "RUN" position on warm engine starts.

4.Grasp handle on rope starter and pull slowly until resistance is felt. Let the rope rewind slowly. Pull rope with a rapid full arm stroke. Let rope rewind slowly. Repeat if necessary.

NOTE: IF ENGINE OIL LEVEL IS TOO LOW, ENGINE WILL NOT START. CHECK OIL LEVEL AND ADD IF NECESSARY.

5.When engine starts, gradually move the choke to the "RUN" position. IMPORTANT: Allow generator to run at no load for 5 minutes upon each initial start-up to allow engine and generator to stabilize.

TO START GENERATOR (Electric start)

1.Open the fuel shut-off valve. See Figure 8.

2.(if equipped) On the engine there is a ON/OFF switch located on the front panel of the engine. Place this switch to the "ON" position.

3.Move the choke control located on the engine to "CHOKE" position. A cold engine may require to be choked longer than a warm engine.

4.Push ON\OFF\START switch on control panel to the "START" position to start engine. Hold in "START" position no longer than 15 seconds per minute when trying to start engine. Extended cranking can damage the starter motor.

5.When engine starts, gradually move the choke to the "NO Choke" position.

IMPORTANT: Allow generator to run at no load for 5 minutes upon each initial start-up to allow engine and generator to stabilize.

13- ENG

D25572

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Generator Consumer Safety Information Consumer General and Service InformationImportant Safety Instructions Safety Guidelines / DefinitionsWhen installing a Double Risk of Electrocution and FireRisk of Electrocution and Fire When damagedOperation Generator in rainUnit Indoors or in ANY Risk of FireConfined Area Risk of Unsafe Operation Risk of Breathing Inhalation HazardRisk of HOT Surfaces Risk from Lifting Risk of Moving PartsTypical Installation of Battery AssemblyRemove Generator from Carton Grounding the GeneratorFor GBE4010 and GBFE6010 Obtaining Electricity from the Generator Double Throw Transfer SwitchExtension Cords Operation Recoil start/Pull start To Start the EngineStopping Engine Connecting Electrical LoadsEngine Maintenance MaintenanceCustomer Responsibilities Table General RecommendationsStorage Generator MaintenanceEngine Preparation GeneratorWattage Calculations Battery Electric Start Units onlyDetermining Wattage Requirements Starting WattsStarting Wattage Requirements Application GuideAppliance or Load Device Typical Device Wattage Total Household Wattage CalculatorStart Troubleshooting GuideResponsibility of Original Purchaser initial User Limited WarrantyCall 1-800-888-2468 EXT Quick Facts

D25572 specifications

DeVilbiss Air Power Company D25572 is a powerful air compressor that embodies cutting-edge technology and robust design, making it an invaluable asset for both professional and amateur users. Renowned for its reliability and performance, the D25572 is widely used in a variety of applications such as automotive tasks, woodworking, and home improvement projects.

One of the standout features of the D25572 is its impressive 6-gallon tank capacity, which allows it to store a substantial amount of compressed air and deliver consistent output without frequent cycling. This is particularly beneficial for users who require extended use of pneumatic tools, ensuring that they can complete tasks efficiently without interruptions for refilling.

Another key characteristic of the D25572 is its powerful 1.5-horsepower motor, which is designed to provide high airflow rates. This motor operates quietly and efficiently, reducing noise levels while still delivering sufficient power to meet demanding workloads. With a maximum pressure of up to 125 PSI, it can easily handle various tasks, from inflating tires to powering air tools.

The design of the D25572 emphasizes user-friendliness and portability. It features a compact, lightweight structure that makes it easy to transport from one job site to another. Additionally, the built-in handle enhances maneuverability, allowing users to move the unit without hassle. The unit also includes rubber feet, providing stability during operation and minimizing vibration.

Moreover, the D25572 incorporates several advanced technologies that enhance its functionality. The oil-free pump design eliminates the need for regular maintenance, making it an ideal choice for users seeking a low-maintenance solution. This feature not only saves time but also contributes to the overall durability of the unit.

The D25572 is equipped with multiple output ports, allowing for the simultaneous use of several air tools. This feature is especially useful for professionals who require versatility in their equipment. The compressor also comes with easy-to-read gauges, enabling users to monitor pressure levels accurately and make adjustments as needed.

In conclusion, the DeVilbiss Air Power Company D25572 air compressor combines efficiency, portability, and advanced technology, making it a top choice for various air-powered applications. Its robust features and user-centric design ensure that it meets the needs of both casual and professional users effectively.
Top Page Image Contents