Xs Series Power Amplifiers
2Setup
2.6.3Bridge-Mono Mode
Typical input and output wiring is shown in
Figure 2.10.
NOTE: Crown provides a reference of wiring pin assignments for commonly used connector types in the Crown Amplifier Application Guide available at www.crownaudio.
OUTPUTS: Connect the speaker across the red binding posts of each channel. Do not use the black binding posts when the amp is being oper- ated in
IMPORTANT: Set the Bridge/Normal switch to “Bridge.”
NOTE: In
Channel 1 Level control is functional.
Figure 2.10 Bridge-Mono Wiring
Operation Manual | page 9 |