Know Your Generator, Specifications

Generac Portable Products PP5000T Generator

KNOW YOUR GENERATOR

Read this owner’s manual and safety rules before operating your generator.

Compare the illustrations with your generator to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference.

Circuit Breakers (AC)

Air Filter

Run/Stop Switch

120 Volt AC, 30 Amp

Locking Receptacle

120/240 Volt AC, 20 Amp

Locking Receptacle

120 Volt AC, 20 Amp Receptacles — May be used to supply electrical power for the operation of 120 Volt AC, 20 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120 Volt AC, 30 Amp Locking Receptacle — May be used to supply electrical power for the operation of 120 Volt AC, 30 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.

120/240 Volt AC, 20 Amp Locking Receptacle — May be used to supply electrical power for the operation of 120 and/or 240 Volt AC, 20 Amp, single phase, 60 Hz AC electrical lighting, appliance, tool and motor loads.

Air Filter — This engine assembly filters air entering the engine.

Circuit Breakers (AC) — Each receptacle is provided with a circuit breaker to protect the generator against electrical overload. Breakers are "push to reset" type.

Fuel Tank

Fuel Shut–Off Valve

Grounding Wing Nut

120 Volt AC, 20 Amp

Receptacles

Fuel Shut Off Valve — Controls fuel supply to engine.

Fuel Tank — Capacity of 4 U.S. gallons.

Grounding Wing Nut — Provides a tie-point for connecting the generator frame to earth ground.

Run/Stop Switch — Must be in “Run” position to start engine. Set to “Stop” to stop a running engine.

SPECIFICATIONS

Rated Maximum Continuous
Wattage Capacity	5000	Watts
Power Factor		1.0
Rated Maximum Continuous Load Current
At 120 Volts	41.67	Amps
At 240 Volts	20.83	Amps
Phase	1-phase
Rated Frequency	60 Hertz