Volt AC, 20 Amp Duplex Receptacles

Generac Portable Products SVP5000 Generator

RECEPTACLES

120 Volt AC, 20 Amp Duplex Receptacles

Each of these receptacles is protected against overload by 20 Amp push-to-reset circuit breaker.

Figure 7 — 120 Volt, 20 Amp Duplex Receptacle

Use each receptacle to operate 120 Volt, 60 Hz, single phase loads requiring up to 2,400 (2.4kW) watts of power at 20 Amps of current (Figure 7).

120/240 Volt AC, 20 Amp Locking Receptacle

Use a NEMA L14-20P plug with this receptacle. Connect a 4-wire cord set rated for 250 Volt loads at 20 AC Amps (or greater) (Figure 8). You can use the same 4-wire cord if you plan only to run a 120 Volt load.

This receptacle powers 120/240 Volt AC, 60 Hz, single phase loads and is protected by a 20 Amp push-to- reset circuit breaker.

Figure 8 — 120/240 Volt, 20 Amp Locking Receptacle

120 Volt AC, 30 Amp Locking Receptacle

Use a NEMA L5-30P plug with this receptacle. Connect a 3-wire cord set rated for 125 Volt AC loads at 30 Amps to the plug (Figure 9).

Figure 9 — 120 Volt, 30 Amp Locking Receptacle

Use this receptacle to operate 120 Volt AC, 60 Hz, single phase loads requiring up to 3,600 watts

(3.6 kW) of power at 30 Amps. The outlet is protected by a 30 Amp push-to-reset circuit breaker.