Coleman PM402511 owner manual Fuel Selection, Carburetor Adjustments, Natural GAS NG Settings

Page 10

FUEL SELECTION

NATURAL GAS (NG) SETTINGS

Units are tested with natural gas before they leave the factory. If natural gas is to be used, no adjustments are required. The fuel select switch, located on the bottom of the control panel, should be in the (NG) position. The (NG) position is with the switch depressed away from the front of the control panel (see A in illustration 1)

LIQUID PROPANE VAPOR (LPG) SETTINGS The fuel select switch position for liquid propane

vapor (LPG) is with the switch depressed toward the front of the control panel (see B in illustration 1).

B

A

Illustration 1

WARNING

•Natural gas (NG) is highly explosive.

•Natural gas (NG) is lighter than air and will collect in high places.

•Liquid propane vapor (LPG) is highly explosive.

•Liquid propane vapor (LPG) is heavier than air and will collect in lower places.

•Extreme caution should be taken when working on a new installation or while performing general maintenance.

•Do not smoke when near the unit.

•Keep flames, sparks, pilot lights, arc-producing equipment, switches and all other sources of ignition well away. Keep a type ABC fire extinguisher handy.

•Potential for fire or explosion always exist when using natural gas (NG) or liquid propane vapor (LPG) as a fuel source. Install this unit in compliance with all local fuel codes.

•Do Not operate engine if smell of fuel is present or other explosive conditions exist.

Per the National Gas Code (NFPA 54 - ANSI 2223.1), a manual shutoff valve in the fuel supply line to the generator is recommended. All fuel system installations MUST BE done by a licensed plumber or licensed gas technician and must comply with all applicable codes, standards and regulations.

CARBURETOR ADJUSTMENTS

The main adjustment screw is located on the side of the fuel mixer (as shown in illustration 2). Start unit at no load and verify proper operation. Loosen jam nut on adjusting screw. Slowly load unit to full load, adjusting load screw counter-clockwise as required to achieve maximum power. Once smooth full load operation is achieved, tighten adjustment screw jam nut, then return unit to no load to verify proper operation.

CAUTION

•This adjustment should only be performed by trained personnel. If incorrect adjustments are made, the unit may fail to operate or operate inefficiently.

Illustration 2

ADJUSTMENT

SCREW

FUEL SPECIFICATIONS

FUEL REQUIREMENTS:

For the best operation of the unit, the fuels used should have a minimum content of 1000 BTU’s per cubic foot for Natural Gas (NG) and 2520 BTU’s per Cubic foot for Liquid Propane vapor (LPG). Contact local fuel supplier for local BTU content. Fuel supply pressures must be between 4oz (7” H20 per square inch) and 6oz (11” H20 per square inch) at the inlet to the unit.

FUEL CONSUMPTION:

The PowerStation 25Kw at full load consumes 306,000 BTU’s per hour of natural gas (NG) and 354,000 BTU’s per hour of liquid propane vapor (LPG).

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents English Francais EspañolTable of Contents General Safety Guidelines General Safety Guidelines Risk of Electrocution AND/OR Injury Introduction Unpacking InstructionsRisk of Injury and Being Crushed Fuel Specifications Generator SpecificationsEngine Specifications DimensionsInstallation Drawings Installation Location and Generator PlacementLocation and Generator Placement Wiring Installation DetailFuel Selection Carburetor AdjustmentsNatural GAS NG Settings Fuel RequirementsAutomatic Transfer Switch Battery Installation Battery Safety InstructionsPrestart Checks Lubrication and CoolingInitial Start UP of Unit Initial Test of the SystemGenerator Control Panel Features Menu Mode Display ModeAlternate Display Mode Generator Control Panel OperationGenerator Control Panel Features Alarms Generator Control Panel Features PRE-ALARMS25KW Wiring Diagram CP500 Controller 25KW Wiring Diagram CP1000 Controller Engine Maintenance Generator MaintenanceTroubleshooting Symptom Possible Cause Corrective ActionCoverage Maintenance LOG Parts Drawing Exhaust System Parts Drawing Enclosure Parts Drawing Cooling System Parts Drawing Door Assembly X 1/2 NPT 064-0069 Parts Drawing Generator Parts Drawing 25KW Breakdown Article Pièce N 061-0188 Parts Drawing Battery Hold Down

PM402511 specifications

The Coleman PM402511 is an innovative and versatile portable generator designed to meet the power demands of outdoor adventures, home backup, and job sites. Renowned for its reliability and efficiency, the PM402511 is an ideal solution for users seeking convenience in a compact form.

One of the standout features of the Coleman PM402511 is its impressive 4000 watts of starting power and 3500 watts of running power. This capacity makes it suitable for powering essential appliances, tools, and devices. Whether you need to keep your refrigerator running during a power outage or power up your tools on a construction site, this generator provides a dependable energy source.

The PM402511 is equipped with an advanced inverter technology that produces clean and stable energy. This feature is especially vital for powering sensitive electronics like laptops and smartphones, as it minimizes the risk of damaging fluctuations in voltage. With its ability to deliver pure sine wave power, users can operate their devices with confidence.

Another significant characteristic of the Coleman PM402511 is its lightweight and compact design. Weighing only around 50 pounds, it is incredibly portable, allowing users to easily transport it to campsites, tailgating events, or remote job locations. The generator’s foldable handles enhance its portability, making it easy to maneuver and store when not in use.

Fuel efficiency is a crucial aspect of any generator, and the PM402511 excels in this regard. With a runtime of up to 8 hours on a 2.6-gallon fuel tank, it can keep your devices powered without the constant need for refueling. Additionally, its quiet operation makes it a great choice for outdoor environments, ensuring that you can enjoy nature without disturbing the peace.

User-friendly controls and proper safety features further enhance the experience with the Coleman PM402511. It includes multiple outlets, including 120V AC outlets and USB ports, allowing you to charge devices simultaneously. Furthermore, it has built-in safety features such as overload protection and low-oil shutdown, ensuring the generator remains safe during operations.

In summary, the Coleman PM402511 is a powerful, efficient, and portable generator that caters to a variety of power needs. With its advanced inverter technology, excellent fuel efficiency, lightweight construction, and safety features, it stands out as an excellent choice for anyone in need of reliable energy on the go.
Top Page Image Contents