8000W Portable Generator
Install Wheel Kit
The wheel kit is designed to greatly improve the portability of your generator.
NOTE: Wheel kit is not intended for
•1/2" or 13mm socket wrench
•1/2" or 13mm open end wrench
•
•Safety glasses
Refer to Figure 2 and install the wheel kit as follows:
1.Tip generator so that engine end is up.
2.Slide axle through both mounting brackets.
3.Slide a wheel over the axle.
NOTE: Be sure to install both wheels with the air pressure valve on the outboard side.
4.Place a washer on axle and then place an
5.Install
CAUTION
• Always wear eye protection when installing/removing
6.Repeat step 3 thru 5 to secure second wheel.
7.Tip generator so that engine side is down.
8.Attach the vibration mounts to the support leg with
9.Attach support leg with M8 x 20 mm cap screws and M8 lock nuts.
10.Return generator to normal operating position (resting on wheels and support leg).
11.Check each fastener to ensure it is secure and the tires are inflated between
Figure 2 — Install Wheel Kit
| Wheel | |
| Flat Washer | |
| Axle | |
Hex Nut |
| |
Support Leg | Cap Screw | |
| ||
Vibration Mount |
| |
Cap Screw | Hex Nut | |
| 7 |