Briggs & Stratton 30208 owner manual Assembly, Install Wheel KIT, Remove Generator From Carton

3500W Portable Generator

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available.

Remove Generator From Carton

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Carton Contents

Check all contents against those listed below:

•Main unit

•Engine oil

•Owner’s manual

•Engine manual

• Wheel kit

If any parts are missing or damaged, call the generator helpline at 1-800-743-4115.

INSTALL WHEEL KIT

NOTE: While the wheel kit is designed to greatly improve the portability of your generator, it is not intended for over-the-road use.

You will need two 1/2” or 13mm open end wrenches or a socket wrench with 1/2" or 13mm sockets, and a 15/16” wrench to install this kit.

Install the wheel kit as follows (Figure 1):

1.Place bottom of generator cradle on a flat surface.

2.Place axle stud through wheel retainer on cradle frame.

3.Use 15/16” wrench to secure axle stud to frame with 5/8-18 jam nut.

4.Install other axle stud in same manner.

NOTE: Be sure to install wheel with raised hub inboard.

5.Tip unit and install wheel. Place flat washer over axle stud.

Figure 1 — Install Wheel Kit

Capscrew
Nut			Jam Nut
Handle			Washer
	Axle
	Stud
Mounting Leg	Capscrew	Wheel	Retaining Pin
Nut
	6