Baldor PC13R, BALDOR GENERATOR manual For Gasoline or Diesel Powered Generator Sets

Page 5

SAFETY WARNINGS

Always treat the electrical circuits as if they were energized.

Disconnect all leads plugged into the unit Prior to working on it.

Have the electrical circuits serviced only by qualified technicians.

Inspect wiring frequently and replace frayed, broken or poor leads.

Do not connect this unit to any building's electrical system unless you utilize an approved transfer switch or the main service entrance switch has been disconnected and locked open.

Circuit overload protection must be provided in accordance with national electrical codes and local regulations.

Check GFCI Receptacles monthly by using the "Test" and "Reset" buttons designed into them.

Depending on your application it may be mandatory to ground or not ground this unit to earth ground. Comply with local electrical codes.

○ ○ ○ ○ FOR GASOLINE OR DIESEL POWERED GENERATOR SETS ○ ○ ○ ○

Operate the generator set on a level surface. If the generator set is tilted, fuel spillage may result.

Handle fuel with care. It is highly flammable. Use only clean, properly marked and approved safety containers for refueling and storing fuel.

Stop the engine and allow it to cool before refueling.

Do not overfill the fuel tank. Only fill the tank to within 1/2" of the top of the tank to allow space for fuel expansion.

If fuel is spilled, wipe it up carefully and wait until the fuel has dried before starting the engine.

Make sure the fuel cap is properly closed after refueling.

Never operate the generator set while smoking.

Never operate the generator set near an open flame.

Never store the generator set with fuel in the tank indoors or in an enclosed, poorly ventilated enclosure where fuel fumes may reach an open flame, electrical spark or pilot light as on a furnace, water heater, clothes dryer, etc.

When transporting over long distances or rough roads, drain the fuel tank to prevent leakage and spillage.

- iv -

Image 5
Contents Operators Manual for Your Forward Safety Warnings Safety Warnings For Gasoline or Diesel Powered Generator Sets Page Section Title Specifications Performance Curves Features General Description Tank \ \ 2CONDENSER Control Panel Voltagefluctuationsunderload DC Output 4ELECTRONIC Ignition System OIL Sensor Option 1DESCRIPTION Oil 5CAUTIONS to be Taken on Handling the Sensor Operator may be injured or suffer electric shock Incandescent lamp, heater, etc. withapower factorof 1.O Appliances without any indication asto power consumption Specific Gravity of Batteryelectrolyte 3BATTERY Capacity Measuringprocedures 3METERFREQUENCY Circuittester IPI Measuring Insulation Resistance Control Panel Checkingfunctionalmembers DC Terminal Measure the resistance of the resister 10 ,uF Checkingtableforanaloguecircuittester Disassembly and Assembly 10-2DISASSEMBLY Procedures Green Driver + Driver Two M8 nuts LOmm box wrench 12mm box wrench + Driver LOmm box wrench Box spanner Stator Rotor Rotor Screw the bolt into the thread Mount Remove mount bracketfrom engine Assemblyprocedures 10-3-1FRONT Bracket Stator 10-3-5ENDCOVER 10-3-9FRONT Cover and Element Cover Control Panel Side Secure the side cover with four M5X8 screws 11= Troubleshooting Mow to adjustengine r.p.m AC circuit breaker Resistor Year Warranty Robin Subaru Limited Engine Warranty For Baldor Generators Limited Warranty Warranty Period Limitations California Proposition 65 Warning Oregon Street Oshkosh WI