Baldor BALDOR GENERATOR, PC13R manual

Page 6

SAFETY WARNINGS

○ ○ ○ ○ FOR GASOLINE OR DIESEL POWERED GENERATOR SETS ○ ○ ○ ○

Check all fuel supply piping and their connections on a monthly basis for fuel leaks.

Use only approved piping and componentry in your fuel supply system.

A professional, experienced technician should only install the fuel supply system.

Do not run the fuel line up against any sharp objects.

Comply with NFPA regulations and your local codes in regard to shut-off valves, regulators, etc. and any other recommendations or requirements they may have.

Keep the generator set at least three feet away from buildings or other structures.

Keep the generator set away from flammable and other hazardous materials (trash, rags, lubricants, explosives, paints, etc.)

Keep the generator set free of grass, leaves and excessive grease and oils.

Allow the generator set to cool before transporting it or storing it indoors.

Have fire extinguisher accessible and nearby while operating the generator set.

This generator set must not be used on or near any forest covered brush covered or grass covered land unless the engine's exhaust system is equipped with a spark arrester and it must be maintained

in effective working order by the operator.

Operation inside an enclosed compartment or building is a potential fire hazard and should not be done unless approval is obtained from Baldor Generators. Engine/Generator overheating can cause severe damage due to restricted, obstructed or improper airflow that is necessary for the proper cooling of the unit.

Hot exhaust gases being discharged by the engine must never be directed toward anything that could catch fire or explode.

- v -

Image 6
Contents Operators Manual for Your Forward Safety Warnings Safety Warnings For Gasoline or Diesel Powered Generator Sets Page Section Title Specifications Performance Curves Features General Description Tank \ \ 2CONDENSER Control Panel Voltagefluctuationsunderload DC Output 4ELECTRONIC Ignition System OIL Sensor Option 1DESCRIPTION Oil 5CAUTIONS to be Taken on Handling the Sensor Operator may be injured or suffer electric shock Incandescent lamp, heater, etc. withapower factorof 1.O Appliances without any indication asto power consumption Specific Gravity of Batteryelectrolyte 3BATTERY Capacity Measuringprocedures 3METERFREQUENCY Circuittester IPI Measuring Insulation Resistance Control Panel Checkingfunctionalmembers DC Terminal Measure the resistance of the resister 10 ,uF Checkingtableforanaloguecircuittester Disassembly and Assembly 10-2DISASSEMBLY Procedures Green Driver + Driver Two M8 nuts LOmm box wrench 12mm box wrench + Driver LOmm box wrench Box spanner Stator Rotor Rotor Screw the bolt into the thread Mount Remove mount bracketfrom engine Assemblyprocedures 10-3-1FRONT Bracket Stator 10-3-5ENDCOVER 10-3-9FRONT Cover and Element Cover Control Panel Side Secure the side cover with four M5X8 screws 11= Troubleshooting Mow to adjustengine r.p.m AC circuit breaker Resistor Year Warranty Robin Subaru Limited Engine Warranty For Baldor Generators Limited Warranty Warranty Period Limitations California Proposition 65 Warning Oregon Street Oshkosh WI