Chicago Electric 90300 manual Pre-Start Checks, See Figure D, See Figure E

Pre-Start Checks:

1.NOTE: During operation, it may be necessary to refer to the Engine manufacturer’s Operation, Maintenance, and Parts manual (included) for detailed information about starting, running, and stopping the Engine.

2.Check to make sure the Engine’s “ON/OFF” Switch is in its “OFF” position.

3.Unscrew and remove the Engine’s Oil Fill Cap located at the bottom of the Engine Crankcase. Check to make sure the oil level is even with the top of the Oil Fill Hole. If necessary, add oil until its level is even with the Oil Fill Hole. Then, screw the Oil Fill Cap back into the Oil Fill Hole. NOTE: Check with the Engine manufacturer’s manual for the proper type of engine oil required for use.

(See Figure D.)

4.Check the Fuel Gauge (34) for the amount of unleaded gasoline in the Fuel Tank (32). If necessary, remove the Fuel Tank Cap (37) and refill the Fuel Tank with un- leaded gasoline. Then, replace the Fuel Tank Cap.

(See Figure E.)

FUELTANK CAP (37) FUEL GAUGE (34)

FUELTANK (32)