![](/images/new-backgrounds/1113680/11368031x1.webp)
Powering Tools And Equipment:
1.Prior to powering tools and equipment, make sure the Generator’s rated voltage, wattage, and amperage capacity (120V/ 20 AMP and 240V/ 20 AMP) is adequate to supply all electrical loads that the unit will power. If powering exceeds the Generator’s capacity, it may be necessary to group one or more of the tools and/or equipment for connection to a separate Generator.
2.Once the Generator is running, simply connect the Power Cords of 120 volt powered tools and equipment into the 120 volt Outlets (43). If a 240 volt tool or equipment is used, connect its power cord into the 240 volt Twistlock Outlet (44). (See Figure I.)
3.NOTE: The Generator features two AC
AC CIRCUIT OVERLOAD BREAKER (42)
120/240 V
TWISTLOCK
OUTLET (44)
120V DUAL OUTLET (43)
FIGURE I
4.When finished using the Generator, turn the ON/OFF switch on the engine’s fan shroud to its “OFF” position, and remove the Ignition Key from the Ignition Switch (45). (See Figure H.)
5.After the Engine and Generator have completely cooled, store the Generator in a safe, clean, dry location (if not already installed in one).
REV 06/04; REV 03/06
SKU 90300 For technical questions, please call | PAGE 16 |