TROUBLESHOOTING
Problem |
| Possible Cause |
| Possible Solution |
Engine will not start. | 1. Low on fuel or oil. | 1. | Add fuel or oil. (See pages 8 & 9.) | |
| 2. | Engine power switch is in the | 2. | Turn engine power switch to the |
|
| OFF position. |
| ON position. (See page 11.) |
| 3. | Faulty spark plug. | 3. | Replace spark plug. |
|
|
|
| (See Engine manual.) |
| 4. | Choke in wrong position. | 4. | Properly adjust choke. |
|
|
|
| (See page 13.) |
| 5. | Fuel valve lever in CLOSED | 5. | Turn fuel valve lever to OPEN |
|
| position. |
| position. (See page 13.) |
| 6. | Generator loaded during | 6. | Remove load from Generator. |
|
|
|
| (See page 14.) |
| 7. | Spark plug wire loose. | 7. | Attach wire to spark plug. |
|
|
|
| (See Engine manual.) |
| 8. | Fuel line clogged. | 8. | Clean fuel line and fuel filter. |
|
|
|
| (See Engine manual.) |
| 9. | Faulty ignition system. | 9. | Have a qualified technician check |
|
|
|
| ignition system. |
No electrical output. | 1. Faulty outlet. | 1. | Have a qualified technician check | |
|
|
|
| outlets. |
| 2. | Circuit breaker tripped. | 2. | Depress circuit breaker and reset. |
|
|
|
| (See page 11.) |
| 3. | Defective capacitor. | 3. | Have a qualified technician check |
|
|
|
| capacitor. |
| 4. | Faulty power cord. | 4. | Repair or replace cord. |
Repeated circuit breaker | 1. Overload. | 1. | Reduce load. (See page 14.) | |
tripping. | 2. | Faulty cords or equipment. | 2. | Check for damaged, bare, or frayed |
| ||||
|
|
|
| wires on equipment. Repair or |
|
|
|
| replace. |
Generator overheating. | 1. Generator overloaded. | 1. | Reduce load. (See page 14.) | |
| 2. | Insufficient ventilation. | 2. | Move to adequate supply of fresh |
|
|
|
| air. (See page 10.) |
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFAC- TURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACE- MENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 93881 | For technical questions, please call | PAGE 16 |